User Manual

22
F
AN MODE
Adjust fan speed by pressing the FAN button (C) as described for the air-conditioning mode.
Remember that the higher the speed, the more air is filtered. If you select "MIN" speed, less air is
filtered but the appliance is also less noisy.
DEHUMIDIFYING MODE
Ideal for reducing the humidity in a room without lowering or raising the temperature (spring or
autumn, damp rooms, rainy spells, etc). When the dehumidifying mode is selected, the light (P)
turn on. In this mode, with temperatures higher than 25°C it is possible to adjust the ventilation
speed.
If the temperature is less than 25°C the ventilation speed will be automatically adjusted by the
appliance and the ventilation light “MED” (L) will turn on.
Note: Remember to install the air exhaust hose as described in the chapter: “Preparing for use”.
PROGRAMMING THE TIMER
The timer can be used to delay appliance start up or shut down. This avoids wasting electricity by
optimising operating periods.
How to programme delayed start up
• Plug the appliance into a mains socket and press the ON/Standby button (A), then select the
required operating mode and other settings (temperature, fan speed, etc).
• Press the ON/Standby button (A) again to place the appliance in standby mode.
• Press the timer button (D). The timer light "H" flashes.
• Use the + (E) or - (F) buttons to set the number of hours delay before the appliance comes on.
• The time increases or decreases in steps of one hour.
The indicator light (H) flashes until the appliance starts up.
You can set the appliance to come on with a delay of up to 12 hours.
To cancel the timer programme, press the timer button (D) again.
Light (H) stops flashing.
How to programme delayed shut down
• Delayed shut down can be programmed in any operating mode (air conditioning / fan/ dehu-
midifying).
• Press the timer button (D). The timer light "H" flashes.
• Use the + (E) or - (F) buttons to set the number of hours delay before the appliance goes off.
The time increases or decreases in steps of one hour.
The light (H) flashes until the appliance turns off as programmed.
At the set time, the air conditioner shuts down and remains in standby.
To cancel the timer programme, press the timer button (D) again.
Light (H) stops flashing.