Use and Care Manual

Delta Heat Service [phone] | 5
PORTABLE LP CONNECTION
NOTE: USE ONLY A 20-LBS. (5-GALLON CAPACITY)
GAS CYLINDER.
WARNING: DO NOT PLACE MORE THAN ONE CYL-
INDER IN THE BASE CABINET ENCLOSURE AT ANY
TIME.
WARNING: DO NOT USE A DENTED OR RUSTED LP
CYLINDER.
NEVER USE A CYLINDER WITH A DAMAGED VALVE.
ALWAYS CHECK FOR LEAKS AFTER CHANGING THE
LP CYLINDER. (Page 7)
THE LP PRESSURE REGULATOR AND HOSE SUP-
PLIED WITH THIS UNIT MUST BE USED WITHOUT
ALTERATION.
ALWAYS USE THE TANK SECURING DEVICE SUP-
PLIED WITH GRILL BASE.
1. To install the gas cylinder, place the cylinder onto the provided cutout.
2. Check to ensure that the tank’s gas valve on top of the cylinder is closed.
3. Connect the LP regulator (included) to the cylinder and hand-tighten only. Open the tank valve
and make sure all connections are leak tight using a soapy water solution and a brush. (Refer-
ence page 7 for leak test procedure).
WARNING
DO NOT STORE SPARE LP GAS CYLINDER UNDER OR NEAR THIS APPLIANCE.
NEVER FILL THE CYLINDER BEYOND 80 PERCENT FULL.
FAILURE TO DO SO, A FIRE CAUSING DEATH OR SERIOUS INJURY MAY OCCUR