Use and Care Manual

16 | www.deltaheat.com
OPERATING INSTRUCTIONS
BEFORE LIGHTING THE GRILL
DO NOT ATTEMPT TO LIGHT THE GRILL IF YOU SMELL GAS.
WARNING! IT IS CRITICAL THAT THE GAS BURNERS ARE PROPERLY INSTALLED WITH
THEIR ORIFICES INSIDE THE BURNERS AIR SHUTTERS. If not properly installed, gas
may leak outside of the burner that could lead to re, potential damage to your grill, bodi-
ly injury or death.
Inspect the gas supply piping or hose prior to turning the gas ON. If there is evidence of cuts,
wear, or abrasion, it must be replaced prior to use. The replacement pressure regulator and
hose assembly must be the type specied by the manufacturer. Do not use the grill if the odor of
gas is present. The pressure regulator and hose assembly supplied with the units must be used.
If the unit is LP, screw the regulator and hand tighten to the valve of the cylinder and leak check
the hose and regulator connections with a soap and water solution before operating the grill.
Reference page 7 for leak test procedure.
Always keep your face and body as far away as possible when lighting.
Refer to spiders and insects warning and procedure under the cleaning and maintenance page
of this manual.
TO LIGHT THE GRILL BURNER
Lighting the Grill
1. Open the grill hood completely. Do not attempt to light the
grill with the hood closed.
2. Open the gas supply shut-off valve.
3. Push in the knob and verify that the spark igniter sparks. If
the igniter does not spark, check the 9V battery. (Reference
page 14 for battery location).
4. Once the sparking is veried simultaneously push-in and
turn the knob counter-clock-wise to the biggest ame mark-
ing on the knob. Hold the knob pushed in for 4 seconds.
Once you see or hear a ame you can release the knob.
For Rotisserie Lighting
Push-in and turn the knob to HIGH. Hold for 30 seconds to
heat up the safety thermocouple and release knob. If the rotisserie
burner will not stay lit, repeat the process.
CAUTION: If ignition does not take place within 4 seconds, turn
knob to the OFF position, wait for ve minutes and repeat step 3
and 4.
5. Close the hood to allow the grill to pre-heat until the hood
thermometer displays the desired grilling temperature.