Use and Care Manual

Delta Heat Service [phone] | 17
OPERATING INSTRUCTIONS - CONT.
Match/BBQ Lighter Lighting Instructions:
If there is no electrical power supply available or if spark igniter
will not light the burners, the burners can be lit manually using a light-
ed long match, taper or BBQ lighter.
1. Push and turn the knob counter-clock-wise to the biggest ame
marking on the bezel. Hold the knob pushed in for 4 seconds.
2. Using the provided match holder, insert a lit match or BBQ
lighter through the grates and near the top of the cross tube of
the burner. Once you see or hear a ame you can release the
knob.
Important: If burner fails to light within 4 seconds, turn off gas and
wait 5 minutes before repeating the process.
Warning: If you smell gas, shutoff the gas supply and immediately
check for leaks using the soapy water technique. (See Page 7)
USING THE GRILL
1. Check to be certain that the drip pan is in place and pushed all the way into the grill.
2. Light the grill burners using the instructions in use and care manual.
3. Turn the control knobs to HI and allow the grill to preheat for 15 minutes or until desired tem-
perature is displayed on the thermometer. The top cover is to be closed during the appliance
preheat period.
4. Place the food on the grill and cook to the desired temperature doneness. Adjust heat setting,
if necessary. The control knob may be set to any position between HI and LO.
5. Allow grill to cool, then clean the drip pan after each use.
INTERIOR LIGHT OPERATION
The DELTA HEAT grill is equipped with interior halogen lights for late night grilling. The grill is
equipped with a switch that controls the functionality of the interior lights.
1. Push the switch located on the left side of front panel to turn ON interior.
WARNING: Do not touch the interior halogen lights. It may be hot and can cause serious burns.
REPLACING INTERIOR LIGHT BULBS
WARNING! Unplug the grill from the 120V power source before replacing the light bulb.
1. Remove the screw that holds the lens cover and slide the lens cover out.
2. Remove the housing from the grill.
3. Loosen the screws that hold the bulb in the light housing.
4. Remove the old light bulb by pulling it straight out of the socket without twisting the light bulb.
5. Wearing plastic gloves, insert the new light bulb into the socket. DO NOT touch bulb with bare
hands as the oil and dirt will shorten bulb life.
6. Slide the light lens back into the light assembly and screw it in to secure it.