User Manual
10 | www.deltaheat.com
BURNER FLAME / AIR SHUTTER ADJUSTMENT
Each Teppanyaki Griddle burner is tested and
adjusted at the factory prior to shipment; however, vari-
ations in the local gas supply may make it necessary to
adjust the burners.
The ames of the U-burners should be visually
checked. Flames should be blue and stable with little
to no yellow tips, no excessive noise or lifting. If any of
these conditions exist, remove the burner and check to
see if the air shutter or burner ports are blocked by dirt,
debris, spider webs, etc. If it is clear, the air shutter may
need to be adjusted.
Before adjusting the air shutter, verify that the correct orice size for the gas type was in-
stalled.
ADJUSTING THE GRILL BURNER FLAME
The amount of air is controlled by a sheet metal cup at the inlet of the burner called an air shut-
ter. It is locked in place by a set screw which must be loosened prior to lighting the burner for adjust-
ment. The air shutter adjustment screws are accessible with a phillips screwdriver. Loosen the lock
screw of the air shutter. Adjust according to the following directions. Be careful as the burner and
other grill parts may be very hot!
• If the ame is yellow, indicating insucient air, turn the air shutter counter-clockwise to allow
more air to the burner.
• If the ame is noisy and tends to lift away from the burner, indicating too much air, turn the air
shutter clockwise.
Remember to tighten the set screw prior to re-installing the burner.
ENSURE THAT THE BURNERS ARE SITTING PROPERLY ON THE ORIFICES BEFORE LIGHT-
ING THE BURNERS.
Burner set to LP Burner set to NG