User Manual

Twin Eagles Service [phone] | 1
GETTING STARTED
Safe and satisfactory operation of the Teppanyaki Griddle depends upon its proper installation. The
installation, adjustments and service of the Griddle must be performed only by a qualied installer and
service technician.
Proper location and proper use is essential to insure safe and continued trouble-free operation. Any
alterations made to the appliance will void the product’s warranty.
Before installing, check the rating/serial plate of the Teppanyaki Griddle. Use only the electrical power
supply and type of gas supply (natural or propane) as specied on the rating/serial plate. This infor-
mation is found on the serial plate, located on the inside wall of the left hand side panel.
Electrical Specication
The appliance should only be taken apart be a qualied technician, or electrical shock may occur. It is
rated at 120V, 60Hz.
Propane or LP
If your Teppanyaki Griddle is factory built for LP, the regulator supplied is set to 11 in wc (2.74 kPa)
and is for use with LP gas only. The factory supplied regulator and hose must be used with a 20 lb LP
cylinder. Do not use any replacement regulator other than that specied by Delta Heat.
Natural Gas or NG
If the Teppanyaki Griddle is factory built for natural gas, the regulator supplied is set for 4” water col-
umn. Do not use any replacement regulator other than that specied by Delta Heat.
Shipment
This Teppanyaki Griddle is inspected before leaving the factory. The shipping carrier assumes full
responsibility for the safe delivery of the appliance. Check for possible shipping damage immediately
after unpacking. If the Teppanyaki Griddle is found to be damaged, save the packaging material and
contact the shipping carrier immediately.
Unpacking
Remove all packaging materials, labels and protective plastic lm. DO NOT LEAVE UNIT UNDER
THE SUN WITH PROTECTIVE FILM ON FOR AN EXTENDED PERIOD OF TIME AS IT WILL BE
DIFFICULT TO REMOVE THE FILM.