Reference Manual

16-Axis MACRO CPU Software Reference Manual
82 16-Axis MACRO Station Memory and I/O Map
8 SEL0 Inversion Control
...
15 SEL7 Inversion Control
(All bits: 0=Non-inverting; 1=Inverting)
(All bits must be 0 to use standard port accessories)
16-23 Not used
Y:$C087 Data Type Control Register
Bits: 0 DISP0 Data Type Control
...
7 DISP7 Data Type Control
8 CTRL0 Data Type Control
...
11 CTRL3 Data Type Control
(These bits are always 1; there is no alternate mode for these pins)
12-23 Not used
X:$C087 Data Inversion Control Register
Bits: 0 DISP0 Inversion Control
...
7 DISP7 Inversion Control
8 CTRL0 Inversion Control
...
11 CTRL3 Inversion Control
(All bits: 0=Non-inverting; 1=Inverting)
(All bits must be 0 to use standard port accessories)
12-23 Not used
Y:$C088-$C08B Not used
X:$C088-$C08B Not used
Y:$C08C Pure binary conversion from gray code input on I/O00 to I/O23
Note:
The pins associated with this register are used for other purposes on the 16-Axis
MACRO Station.
X:$C08C DAC Strobe Word, 24 bits
(Shifted out MSB first, one bit per DACCLK cycle, starting on rising edge
of phase clock)
Y:$C08D Gray-to-binary conversion bit-length control
Note:
The pins associated with this register are used for other purposes on the 16-Axis
MACRO Station.
Bits: 0-3 Bit length of less significant word portion (I/O00 - I/Onn)
4 =1 specifies 16-bit lower / 8-bit upper conversion
5-23 Not used
X:$C08D Not used
Y:$C08E MACRO Node Enable Control (I996)
Bits: 0 Node 0 enable control
...
15 Node 15 enable control
(0=node disable; 1=node enable)