Reference Manual

Turbo PMAC/PMAC2 Software Reference
Turbo PMAC On-line Command Specification 385
matches the existing password correctly, Turbo PMAC accepts it as a valid command, and the host
computer has access to the protected programs until the Turbo PMAC is reset or has its power cycled.
If the command does not match the existing password correctly, Turbo PMAC returns an error (reporting
ERR002 if I6=1 or 3), and the host computer does not have access to the protected programs. The host
computer is free to attempt to match the existing password.
There is no way to read the current password. If the password is forgotten and access to the protected
programs is required, the card must be re-initialized with the $$$*** command, which clears all program
buffers as well as the password. Then the programs must be reloaded, and a new password entered.
Example:
{Starting from power-up/reset with a null password}
LIST PLC 1 ; Request listing of protected program
P1=P1+1 ; PMAC responds because there is no password
RETURN
PASSWORD=Bush ; This sets the password to "Bush"
LIST PLC 1 ; Request listing of protected program
P1=P1+1 ; PMAC responds because password has been
RETURN ; matched by changing it.
$$$ ; Reset the card
LIST PLC 1 ; Request listing of protected program
ERR002 ; PMAC rejects because password not entered
PASSWORD=Reagan ; Attempt to enter password
ERR002 ; PMAC rejects as incorrect password
PASSWORD=BUSH ; Attempt to enter password
ERR002 ; PMAC rejects as incorrect (wrong case)
PASSWORD=Bush ; Attempt to enter password; PMAC accepts as correct password
LIST PLC 1 ; Request listing of protected program
P1=P1+1 ; PMAC responds because password matched
RETURN
PASSWORD=Clinton ; This changes password to Clinton
LIST PLC 1 ; Request listing of protected program
P1=P1+1 ; PMAC responds because password has been
RETURN ; matched by changing it.
$$$ ; Reset the card
PASSWORD=Clinton ; Attempt to enter password
; PMAC accepts as correct password
LIST PLC 1 ; Request listing of protected program
P1=P1+1 ; PMAC responds because password matched
RETURN
See Also:
On-line commands LIST, LIST PC, LIST PE, OPEN
PAUSE PLC
Function: Pause specified PLC programs.
Scope: Global
Syntax: PAUSE PLC {constant}[,{constant}...]
PAU PLC {constant}[,{constant}...]
PAUSE PLC {constant}[..{constant}]
PLC {constant}[..{constant}]
where:
{constant} is an integer from 0 to 31, representing the program number