Reference Manual

ManualsBrandsDelta Tau ManualsControllersDelta Tau PMAC2 PCI

311

312

313

314

315

316

317

318

319

320

Turbo PMAC/PMAC2 Software Reference

Turbo PMAC On-line Command Specification 314

DELETE CCUBUF

Function: Erase extended cutter-compensation buffer

Scope: Motor specific

Syntax: DELETE CCBUF

DEL CCBUF

This command causes Turbo PMAC to erase the extended cutter-radius compensation move buffer for the

addressed coordinate system, freeing that memory for other use.

Turbo PMAC will reject this command, reporting an ERR003 if I6 = 1 or 3, if any CCBUF exists for a

lower-numbered coordinate system, or if any LOOKAHEAD or GATHER buffer exists on the board.

Any of these buffers must be deleted first. CCBUFs must be deleted from low-numbered coordinate

system to high-numbered coordinate system.

See Also:

Cutter Radius Compensation

On-line command DEFINE CCBUF

Program commands CC0, CC1, CC2, CCR

DELETE COMP

Function: Erase leadscrew compensation table

Scope: Motor specific

Syntax: DELETE COMP

DEL COMP

This command causes Turbo PMAC to erase the compensation table belonging to the addressed motor,

freeing that memory for other use.

Note:

Turbo PMAC will reject this command, reporting an ERR003 if I6=1 or 3, if any

COMP buffer exists for a lower numbered motor, or if any TCOMP, BLCOMP,

TBUF, ROTARY, or GATHER buffer exists. Any of these buffers must be

deleted first. COMP buffers must be defined from high-numbered motor to low-

numbered motor, and deleted from low-numbered motor to high-numbered motor.

Remember that a compensation table belonging to a motor does not necessarily affect that motor or is not

necessarily affected by that motor. The command LIST COMP DEF will tell which motors it affects

and is affected by.

Example:

#2DEL COMP.... ; Erase table belonging to Motor 2

ERR003 ............. ; Turbo PMAC rejects this command

#1 DELETE COMP ; Erase table belonging to Motor 1

#2 DELETE COMP ; Erase table belonging to Motor 2