Installation Guide

7
4
1
2
3
1/2" (12.70mm) IPS
Note: Be careful when bending the
copper tubing. Kinked tubes will void
the warranty. Choose hook-ups for 1/2"
I.P.S. connections: (1) Ball nose riser (3/8"
O.D. copper tubing), or (2) 1/2" I.P.S. fau-
cet connector. Use the enclosed coupling
nuts (3) with the ball nose risers (1).
Supply Line Connections
For models with fittings.
1
2
1/2" (12.70mm) IPS
3
5
2
3
1
Remove aerator (1) and turn faucet
handle (2) to the full on mixed position.
Turn on hot and cold water supplies (3)
and flush water lines for one minute.
Important: This flushes away any
debris that could cause damage to
internal parts.
Check all connections at arrows for
leaks. Re-tighten if necessary, but do
not overtighten.
Flush the System and
Check for Leaks
Important: Use two wrenches when
tightening. Do not over tighten.