Installation Guide

ManualsBrandsDelta ManualsBar FaucetsPilar Single-Handle Bar Faucet in Chrome

Models/Modelos/Modèles

4380T-DST & 1980T-DST

Series/Series/Seria

SILICONE

2/9/12 Rev. E

ASME A112.18.1 / CSA B125.1

ACC / ANSI A117.1

SINGLE LEVER TOUCH KITCHEN FAUCETS

LLAVES DE AGUA MONOMANDO / UNA

MANIJA DE ACTIVACIÓN AL TACTO

ROBINETS À UNE MANETTE COMMANDÉS

AU TOUCHER POUR ÉVIERS DE CUISINE

63585

Write purchased model number here.

Escriba aquí el número del modelo comprado.

Inscrivez le numéro de modèle ici.

MEETS OR EXCEEDS — ASME A112.18.1 / CSA B125.1

ALCANZA O EXCEDE LAS SIGIENTES NORMAS —

ASME A112.18.1 / CSA B125.1

WARNING: THIS FAUCET IS NOT TO BE USED WITH PORTABLE

DISHWASHERS! / ADVERTENCIA: ¡SESTA LLAVE NO SE DEBE UTILIZAR

CON MAQUINAS LAVAPLATOS PORTATILES! / AVERTISSEMENT: ON NE

DOIT PAS BRANCHER UN LAVE-VAISSELE PORTATIF SUR CE ROBINET!

LE ROBINET EST CONFORME OU SUPÈRIEUR AUX EXIGENCES DES

NORMES SUIVANTES: ASME A112.18.1 / CSA B125.1

You may need/Usted puede necesitar/

Articles dont vous pouvez avoir besoin:

Para instalación fácil de su llave Delta

usted necesitará:

•LEER TODAS las instrucciones completamente

antes de empezar.

•LEER TODOS los avisos, cuidados, e

información de mantenimiento.

For easy installation of your Delta

faucet you will need:

•ToREAD ALL the instructions completely

before beginning.

•  To  READ ALL warnings, care, and maintenance

information.

Pour installer votre robinet Delta

facilement, vous devez:

•LIRE TOUTES les instructions avant de débuter;

•LIRE TOUS les avertissements ainsi que toutes

les instructions de nettoyage et d’entretien.

SILICONE

www.deltafaucet.com

Summary of content (16 pages)

PAGE 1
SINGLE LEVER TOUCH KITCHEN FAUCETS LLAVES DE AGUA MONOMANDO / UNA MANIJA DE ACTIVACIÓN AL TACTO ROBINETS À UNE MANETTE COMMANDÉS AU TOUCHER POUR ÉVIERS DE CUISINE 63585 ASME A112.18.1 / CSA B125.1 ACC / ANSI A117.1 Models/Modelos/Modèles 4380T-DST & 1980T-DST Series/Series/Seria Write purchased model number here. Escriba aquí el número del modelo comprado. Inscrivez le numéro de modèle ici.
PAGE 2
DELTA® ELECTRONIC FAUCET LIMITED WARRANTY All parts and finishes of the Delta® faucet are warranted to the original consumer purchaser to be free from defects in material & workmanship for a period of 5 years. Delta Faucet Company recommends using a professional plumber for all installation & repair. Delta will replace, FREE OF CHARGE, during the warranty period, any part or finish that proves defective in material and/or workmanship under normal installation, use & service.
PAGE 3
RP40650 Set Screw Tornillo de Ajuste Vis de calage 4380T-DST RP50786s Red/Blue Button Botón rojo/azul Bouton rouge/bleu RP60615s Kitchen Spout Assembly Ensamble del Surtidor para la cocina Bec de robinet d’évier de cuisine RP53998 Aerator Aereador Aérateur RP46245 Wrench Llave Clé RP53214▲ Handle w/Button & Set Screw Manija con botón y tornillo de presión Poignée avec bouton et vis de calage RP53215▲ Sleeve Manja Manchon RP50788 Gasket Empaque Joint RP51503 Bonnet Bonete Chapeau RP50784 Clip, O-Ring &
PAGE 4
RP50787▲ Support Assembly Ensamble del Soporte Support RP10345 O-Rings (3) Anillos O (3) Joints torique (3) RP53880▲ Spray & Hose Assembly Ensamble del Rociador y la mangueraDouchette Douchette et tuyau souple RP50781▲ Soap Dispenser (Purchased Separately) Dispensador de jabón. (Compre por separado) Distributeur de savon (Article vendu spéparément) Other useful accessories that may be purchased separately. Otros accesorios útiles que se pueden comprar por separado.
PAGE 5
1 Top Mount Sinks / Instalación por Encima / Bâti supérieur A. C. 1 1/4" Min. From Center Line To Sink Bowl. 1 1/4" Mínimo. De la línea de centro para hundir el tazón de fuente. 1 1/4" ; Minimal. De la ligne centrale pour descendre la cuvette. 8 2 A 1 B. 7 4 9 1 7 3 10 5 10 6 Determine if your sink is installed from the top of the counter or from the bottom. If your sink is installed from the top use this page for your spout installation. C. SHUT OFF WATER SUPPLIES.
PAGE 6
1 Under Mount Sinks / Instalación por Debajo / Sous le bâti A. C. 1 1/4" Min. From Center Line To Sink Bowl. 1 1/4" Mínimo. De la línea de centro para hundir el tazón de fuente. 1 1/4" ; Minimal. De la ligne centrale pour descendre la cuvette. 2 A 7 1 6 B. 10 3 10 6 1 4 5 9 8 10 4 Determine if your sink is installed from the top of the counter or from the bottom. If your sink is installed from the bottom use this page for your spout installation. C. SHUT OFF WATER SUPPLIES.
PAGE 7
2 A. C. B. 2 4 3 2 3 2 1 4 2 4 3 5 1 C. From underneath the sink, slide the solenoid assembly (1) up A. For this step, use the bag marked “2” plus the other part(s) shown above. B. Slide the gasket (1) up over tubes, mounting stud and wires of valve assembly, then install into groove in base (2). Feed tubes and wire down through hole in sink making sure that the gasket is properly seated. Note: If surface is rough or uneven use silicone under the gasket.
PAGE 8
E. D. 2 1 1st 3 2 1 2 2nd 4 3 4 1 6 6 2 5 5 3 1 3rd Incorrect Installations. Instalacións incorrecta. D. Slide hose assembly (1) onto the solenoid nipple (2). Install clip (3) over hose (1) and nipple (2) to secure connection. Pull down moderately to ensure the connection has been made. E. Push outlet tube nipple (4), on the other end of the hose, into the diverter port (5). Installations incorrecte. Snap clip (6) over tube nipple (4) to lock into place.
PAGE 9
3 A. D. C. 3 3 2 B. 3 1 3 3 1 1 1 2 2 2 A. For this step, use the bag marked “3” plus the other part(s) shown above. C. For Models With A Side Spray - Pull on clip (1) until disengaged. Pull B. For Models With A Side Spray - Mount the spray support (1) in far right D. For Models With A Side Spray - Keeping clip (1) disengaged, insert A. Para este paso, utilice las piezas en la bolsa marcada “3”. C.
PAGE 10
E. F. AA 3 AA 4 AA 2 1 A. 3 8 AA 3 3 AA AA 6 4 G. 2 4 lation Checadora la tour Instal Valve la Válvu non-re Checkación de clapet de Instal lation du 2 Instal 1 1 tial to is essen ing it . plumb y stops of your suppl tion your onto r opera hten). blies e prope overtig assem ial inTo ensur valve water stop. (do not esenc tant: ría es istro de agua. Impor l these checkinto cold and tighten plome (1) (2) de su del sumin instal valve page 2. ferrule topes nto debido 1.
PAGE 11
E. D. B. 1 OR 2 C. 1 O 2 1 1 3 3 OU 1 4 2 2 4 2 Water Line Connections B. Important: To ensure proper operation of your plumbing it is essential to install these check valve assemblies onto your supply stops. Insert ferrule (1) into cold water stop. C. Thread on check valve (2) and tighten. DO NOT OVERTIGHTEN. Repeat steps A & B for hot water stop. E. Custom Fit Connections D. Ensure all fittings and end connections are free of debris.
PAGE 12
Correct method Método Correcto Bonne méthode Incorrect Installation Instalación Incorrecta Installation Incorrecte 2 3 1 4 Custom Fit Connections - Plastic Sleeve Installation Instructions 1. Identify desired length of tube (1). Leave 1" - 2" of extra length to allow for easier installation and cut tube. Ensure cut is straight and burr free. 2. Slide nut (2) and plastic sleeve (3) onto cut tube. Ensure sleeve is oriented as shown. 3. Insert tube into outlet fitting (4).
PAGE 13
F. 5 1 3 2 2 3 1 2 4 4 Soap Dispenser Installation F. Remove aerator (1) using supplied wrench (2) and move faucet handle (3) to the full on mixed position. Turn on hot and cold water supplies (4) and flush water lines for one minute. IMPORTANT: This flushes away any debris that could cause damage to internal parts. Reinstall aerator. Check all connections at arrows for leaks. Re-tighten if necessary, but do not overtighten. Turn (move) faucet handle to the “OFF” position.
PAGE 14
A. Optional Opcional Facultatif C. 2 2 1 1 AA AA AA B. 3 1 2 Manual Bypass of Electronic Features A. Remove the battery pack (1)from the Pilar battery cable (2). B. Disconnect the two spade contacts (1) black wire“-” and (2) red wire “+”from the solenoid body (3) Setting The Handle Limit Stop (Optional) This faucet includes an integrated handle limit stop that has two positions. Position 1, to the left, allows full handle motion (the full range between “all cold” to “all hot”).
PAGE 15
Cleaning the Screen 1 B1. 1/8" 2 B2. B3. 3 7 3 6 4 5 4 8 Maintenance Timeout Feature: Water will stop flowing 4 minutes after the faucet is last touched. If faucet exhibits very low flow: A. Remove and clean Aerator (1) with supplied wrench (2). B. SHUT OFF WATER SUPPLIES. Check and clean screen (3) located in solenoid valve (4). C. SHUT OFF WATER SUPPLIES. Replace valve cartridge (5). When reinstalling parts, make sure bonnet nut (6) is tightened securely with a wrench.
PAGE 16
Solenoid Troubleshooting 3. If your LED base indicator is not displaying any lights, a. Check to make sure the LED connector is plugged into the solenoid / electronics kit. If it is disconnected, or loose (see step 3E), reattach and check for proper operation. b. Replace batteries. c. If it is plugged and the light still does not display on the indicator at the base of the spout, replace the spout assembly**.