Installation Guide

ManualsBrandsDelta ManualsBathtubs245430AL00

Acrylic with Innovex™ Technology Bathtub

Bañera de acrílico con tecnología

Innovex™

Baignoires acryliques avec technologie

InnovexMC

Para instalar fácilmente su bañera

de acrílico Delta necesitará lo

•LEER TODAS las instrucciones

completamente antes de empezar.

•LEER TODOS los avisos, cuidados,

e información de mantenimiento.

•Comprar las conexiones correctas para

el suministro de agua.

For easy installation of your

Delta acrylic tub you will need to:

•READ ALL the instructions completely

before beginning.

•READ ALL warnings, care, and

maintenance information.

•Purchase the correct water supply

components.

You may need:/Usted puede necesitar:/

Articles dont vous pouvez avoir besoin:

Pour une installation facile de votre

baignoire acrylique Delta, vous

devrez :

•LIRE TOUTES les instructions avant

de débuter.

•LIRE TOUS les avertissements ainsi que

toutes les instructions de nettoyage et

d’entretien.

•Acheter le bon nécessaire

de raccordement.

5/9/16 Rev. C

*Some installations may require two pieces of cardboard

*Algunas instalaciones pueden requerir el uso de dos pedazos de cartón.

*Certaines installations peuvent nécessiter deux morceaux de carton.

AG07429

Consult your local plumbing codes prior to installation.

Consulte los códigos/normas locales de plomería antes de

realizar la instalación.

Consultez les codes de plomberie de votre région avant

l’installation.

1/8” Drill Bit

Broca de taladro de

3,2 mm (1/8”)

Foret de 1/8 po

Phillips Screw Bit

Broca de taladro Phillips

Embout Phillips

Sealant

Sellador

Produit d'étanchéité

Cardboard*

Cartón*

Carton*

#8 X 1” Wood Screws

Tornillos para madera n.º 8 x 2,5 cm (1 in).

Vis à bois nº 8 x 1 po

Write purchased model number here.

Escriba aquí el número del modelo comprado.

Inscrivez le numéro de modèle ici.

Registre su sistema de baño en Deltafaucet.com

Inscrivez votre système de bains à Deltafaucet.com

Summary of content (8 pages)

PAGE 1
Acrylic with Innovex™ Technology Bathtub Bañera de acrílico con tecnología Innovex™ Baignoires acryliques avec technologie InnovexMC Write purchased model number here. Escriba aquí el número del modelo comprado. Inscrivez le numéro de modèle ici. Register your bathing system at Deltafaucet.com Registre su sistema de baño en Deltafaucet.com Inscrivez votre système de bains à Deltafaucet.
PAGE 2
Acrylic with Innovex™ Technology Bathtub Limited Warranty All parts and finishes of the Delta® acrylic with Innovex™ Technology bathtub units are warranted to the original consumer purchaser to be free from defects in material and workmanship for the time periods listed below. Delta recommends using a professional plumber for all installation and repair.
PAGE 3
1 2 A. B. A. B. De pth Height dth Wi A. Check unit dimensions in specific areas as shown. Verify that framing dimensions will accomodate product. Consult specifications on pages 12-13 for your specific unit to ensure site requirements are met - if you do not have specifications for your unit, they can be found at www.deltafaucet.com/ bathingsystems. B. Clean debris from area and check for square and level of framing (including floor). A. Clear any debris from opening before sliding in unit.
PAGE 4
3 4 A. B. A. B. C. 91/ 8” Size of Shim Tamaño de la cuña Dimensions des cales 8” Back View Vista posterior Vue arrière ” 10 shim cuña cales A. Mark unit position on all sides of framing before unit is leveled. B. Check level left to right and front to back. A. Mark drain location on floor. B. Pull unit out of framing. C. Make 8”x 10” cutout around waste pipe for drain.
PAGE 5
6 A. B. C. A. B. C. 1 2 A. Clear any debris and slide unit back into framing. B. Pre-drill unit with 1/8” drill bit approximately every 8” vertically and on every stud location along the top flange using dimples as guides. DO NOT drill into studs at this time. C. Insert shims to fill any gaps. This will prevent warping and breakage. A. Use #8 x 1” wood screws to install this product. B. Score shims and remove excess shim material around flange. C.
PAGE 6
Congratulations on Your Purchase of a GREENGUARD Certified Product • GREENGUARD Children & Schools educational settings and other sensitive environments GREENGUARD…creating healthier indoor environments. More than 300 manufacturers voluntarily participate in the GREENGUARD ProgramSM, resulting in the more than 11,000 products.
PAGE 7
Specifications for 245430AL00 Left Drain Tub Specifications for 245430AR00 Right Drain Tub Especificaciones de 245430AL00 Bañera con desagüe a la izquierda Especificaciones de 245430AR00 Bañera con desagüe a la derecha Caractéristiques techniques pour les modèles 245430AL00 Baignoire avec conduite de vidange à gauche 1-1/16” WALL - FIRST NAIL GUIDE 1-1/16” DE LA PARED – PRIMERA GUÍA DE CLAVOS MUR 1-1/16 PO – PREMIER GUIDE 1-1/16” NAIL GUIDE SPACING (TYP.
PAGE 8