Installation Guide

ManualsBrandsDelta ManualsAlcove TubsClassic 400 Curve 5 ft. Left Drain Soaking Tub in White

101335 Rev. B

3/20/18

www.deltafaucet.com

RP79200

Apron Support

Soporte de zócalo

Support de tablier

Model / Modelo / Modéle

Write purchased model number here. Retain

these instructions for future use.

Escriba aquí el número del modelo comprado.

Conserve estas instrucciones para usarlas en el futuro.

Inscrivez le numéro de modèle ici. Conservez

ces instructions pour consultation.

We’re here to help! Please do not return

your product to the store. For questions,

installation support, missing or replacement

parts, contact us rst.

¡Estamos aquí para servirle! Por favor, no

devuelva el producto a la tienda. Para hacer

preguntas, obtener ayuda con la instalación,

piezas que le falten o de repuesto,

contáctenos primero.

Nous sommes là pour vous aider! Ne

retournez pas votre produit au magasin. Si

vous souhaitez obtenir des renseignements,

du soutien pour l’installation ou des pièces de

rechange ou si des pièces sont manquantes,

communiquez d’abord avec nous.

www.deltafaucet.com

1-800-355-2721

consumercare@deltafaucet.com

B10311-6032L-WH

B10311-6032R-WH

40034L

40034R

40114L

40114R

B10513-6030L-WH

B10513-6030R-WH

B10513-6032L-WH

B10513-6032R-WH

DIRECT-TO-STUD BATHTUB

BASE PARA DUCHA PENTAGONAL

BAIGNOIRE FIXÉE AUX MONTANTS

101335

Summary of content (10 pages)

PAGE 1
DIRECT-TO-STUD BATHTUB BASE PARA DUCHA PENTAGONAL BAIGNOIRE FIXÉE AUX MONTANTS Model / Modelo / Modéle 40034L 40034R Write purchased model number here. Retain these instructions for future use. Escriba aquí el número del modelo comprado. Conserve estas instrucciones para usarlas en el futuro. Inscrivez le numéro de modèle ici. Conservez ces instructions pour consultation. ? B10311-6032L-WH B10311-6032R-WH We’re here to help! Please do not return your product to the store.
PAGE 2
REQUIREMENTS FOR SUCCESSFUL INSTALLATION REQUISITOS PARA UNA INSTALACIÓN EXITOSA EXIGENCES À RESPECTER POUR RÉUSSIR L’INSTALLATION KNOWLEDGE BASE: Framing Plumbing • Confirm that your model will fit in intended location and plumbing fixtures are located where required before beginning installation. • Walls and sub-floor must be solid, plumb, and square. • Allow product to reach room temperature for 30 minutes before installation • Do not install in areas where temperature may drop below 32ºF (0ºC).
PAGE 3
TOOLS AND MATERIALS CHECKLIST LISTA DE VERIFICACIÓN DE HERRAMIENTAS Y MATERIALES LISTE DE VÉRIFICATION DES OUTILS ET DU MATÉRIAL REQUIS Caulk Gun Pistola para sellar Pistolet à calfeutrer Tape Measure Cinta métrica Ruban à mesurer Pencil Lápiz Crayon Sealant (2 tubes) Sellador (2 tubos) Composé d’étanchéité (2 tubes) Safety Glasses Antiparras de seguridad Lunettes de sécurité Level Nivel Niveau Square Escuadra Angle droit Shims Cuñas Cales Drop Cloth Lona protectora Toile de protection Drill Tal
PAGE 4
ROUGHING-IN • • • Rough plumbing must be installed before bathtub installation. For masonry construction, floor and walls must be framed to accommodate plumbing and installation. Right side plumbing rough-in shown. IMPORTANT: IF INSTALLING MATCHING WALL SET, refer to Wall Set Installation Manual for specific lumber sizes and placement. Additional studs will be required and need to be installed at this point. TUBERÍA INTERNA • • • La tubería interna debe ser instalada antes de instalar los paneles.
PAGE 5
Required For Proper Installation Entire bottom support must be in contact with a flat level surface as shown below. IF INSTALLATION SURFACE IS NOT LEVEL, use leveling compound or mortar bed for proper installation. Requerida Para Una Instalación Correcta Todo el soporte inferior debe estar en contacto con una superficie plana y nivelada. SI LA SUPERFICIE DE LA INSTALACIÓN NO ESTÁ NIVELADA, para una instalación adecuada use compuesto nivelador o lecho de mortero.
PAGE 6
1 1 1 IF THE SUBFLOOR IS NOT FLAT AND LEVEL SI LA SUPERFICIE DE LA INSTALACIÓN NO ESTÁ NIVELADA SI LE FAUX-PLANCHER N’EST PAS PLAT ET DE NIVEAU A IF THE SUBFLOOR IS NOT FLAT AND LEVEL, it is recommended to put down a mortar bed where the base will be positioned. Inner Posts B10513-6030L-WH B10513-6030R-WH 40114L 40114R Outer Posts 40034L 40034R B10311-6032L-WH B10311-6032R-WH B10513-6032L-WH B10513-6032R-WH Protect bathtub finish by overturning it onto a clean, soft surface such as a drop cloth.
PAGE 7
2 3 2 Less than 1/8” gap. Menos de 1/8” de brecha Écart inférieur à 1/8 po 1 1 1 2 1 3 2 Verify Bathtub Fit Prepare Bathtub • Position bathtub as shown above. Use level (1) and square (2) to verify that it is positioned straight and square. • Drill 3/16” clearance holes at all stud locations on top flanges (1), and along side flanges (2). Do not drill holes directly into studs. Drill chuck can cause damage to product. Use an extended bit holder to reduce risk of drill chuck hitting panels.
PAGE 8
4 5 Overflow Rebosadero Trop-plein Secure Bathtub • Attach drain and overflow following manufacturer’s instructions. • Place drop cloth in bathtub and stand inside bathtub to press it to floor when securing to wall studs. NOTE: Drain/overflow assembly should be sized for 16 1/2” (41.91 cm) deep bathtub. • Secure flanges to wall studs with 1 1/4” panhead or roundhead screws. Drill chuck can damage tub surface. Use an extended bit holder to reduce risk of drill chuck hitting tub surface.
PAGE 9
CARE AND CLEANING 6 We recommend that you clean your acrylic bathing product with mild detergents. Use a terry cloth towel, soft cloth, or sponge. Avoid using abrasive scrubbing pads, steel wool, or sponges. After cleaning, rinse thoroughly with water. NOTICE When using drain cleaner or clog remover, rinse thoroughly with water. Certain chemicals and cleaners may deteriorate the acrylic surface, causing cracks and, potentially, property damage.
PAGE 10
Limited Warranty on Bathing Products This bathing product is warranted to the original consumer purchaser or commercial user, as applicable, to be free from defects in material and workmanship for the applicable period specified below: Delta®Tubs, Shower Bases, and Walls: Ten (10) years from the date of purchase by the original consumer purchaser or, for commercial users, one (1) year from the date of purchase.