Installation Guide

ManualsBrandsDelta ManualsBathroom Sink Faucets501LF-WF

SINGLE HANDLE LAVATORY

CENTERSET FAUCETS

LLAVES MONOCONTROL

DE MONTURA DE CENTRO

PARA LAVAMANOS

ROBINETS À ENTRAXE

COURT À UNE POIGNÉE

Write purchased model number here.

Escriba aquí el número del modelo comprado.

Inscrivez le numéro de modèle ici.

You may need/Usted puede necesitar/

Articles dont vous pouvez avoir besoin:

9/7/16 Rev. D

1/8"

73421

Models/Modelos/Modèles

501LF-WF & 520LF-WFMPU

Series/Series/Seria

www.deltafaucet.com

Para instalación fácil de su llave Delta

usted necesitará:

• LEER TODAS las instrucciones completamente

antes de empezar.

• LEER TODOS los avisos, cuidados, e

información de mantenimiento.

• Comprar las conexiones correctas para el

suministro de agua.

For easy installation of your Delta

faucet you will need:

• To READ ALL the instructions completely

before beginning.

• To READ ALL warnings, care, and maintenance

information.

• To purchase the correct water supply hook-up.

Pour installer votre robinet Delta

facilement, vous devez:

• LIRE TOUTES les instructions avant

de débuter;

• LIRE TOUS les avertissements ainsi que toutes

• Acheter le bon nécessaire de raccordement.

Summary of content (8 pages)

PAGE 1
73421 SINGLE HANDLE LAVATORY CENTERSET FAUCETS LLAVES MONOCONTROL DE MONTURA DE CENTRO PARA LAVAMANOS ROBINETS À ENTRAXE COURT À UNE POIGNÉE Models/Modelos/Modèles 501LF-WF & 520LF-WFMPU Series/Series/Seria Write purchased model number here. Escriba aquí el número del modelo comprado. Inscrivez le numéro de modèle ici.
PAGE 2
CLEANING AND CARE Care should be given to the cleaning of this product. Although its finish is extremely durable, it can be damaged by harsh abrasives or polish. To clean, simply wipe gently with a damp cloth and blot dry with a soft towel.
PAGE 3
4 5 3 1 2 Maintenance If faucet exhibits very low flow: A. Remove and clean Aerator (1) with supplied wrench (2), or B. SHUT OFF WATER SUPPLIES. Replace valve cartridge (3). When reinstalling parts, make sure bonnet nut (5) is tightened securely with a wrench.* If faucet leaks from under handle: Remove handle and unthread trim cap (4). Using a wrench, ensure bonnet nut (5) is tight. If leak persists–SHUT OFF WATER SUPPLIES. Replace valve cartridge (3).
PAGE 4
1 A. 2 1 2 1/2" (12.70mm) IPS B. 3 1 1 2 1 2 2 Supply Line Connections A. Position faucet (1) and gasket (2) on sink. Option: If sink is uneven, Note: Be careful when bending the copper tubing. Kinked tubes will void the warranty. Choose hook-ups for 1/2” I.P.S. connections: (1) Ball nose riser (3/8” O.D. copper tubing), or (2) 1/2” I.P.S. faucet connector. Use the enclosed coupling nuts (3) with the ball nose risers (1). Important: Use two wrenches when tightening. Do not overtighten.
PAGE 5
B E. D. C 1 SIL NE I CO 3 A. 1 2 3 2 3 2 1 1 1 F. G. 4 2 2 H. 5 4 3 2 1 5 1 2 3 2 1 6 Step 3b Metal Pop-Up A. Remove stopper (1) and flange (2). B. Screw nut (1) all the way down. Push washer (2) and gasket (3) down. C. Remove tailpiece (1) from body (2), add plumber’s tape (3), replace tailpiece. Desagüe Automático de Metal Step 3c D. Apply silicone to underside of flange (1). Insert body (2) into sink. Screw flange (1) into body (2). E. Pivot (1) must face faucet.
PAGE 6
4 3 1 2 4 4 Remove aerator (1) using supplied wrench (2) and move faucet handle (3) to the full on mixed position. Turn on hot and cold water supplies (4) and flush water lines for one minute. Important: This flushes away any debris that could cause damage to internal parts. Reinstall aerator. Check all connections at arrows for leaks. Re-tighten if necessary, but do not overtighten.
PAGE 7
5 1 2 Setting The Handle Limit Stop (Optional) This faucet includes an integrated handle limit stop that has two positions. Position 1, to the left, allows full handle motion (the full range between “all cold” to “all hot”). The faucet is set in position 1 in the factory. Position 2, to the right, allows half of the normal handle motion (“all cold” to “mixed hot/cold”). The handle limit stop can be adjusted by the homeowner once the faucet is installed.
PAGE 8
RP5648 Stopper Tapón Bonde RP52833 Handle & Set Screw Manija y Tornillo de Ajuste Manette et Vis de Calage RP47666 Set Screw Tornillo de Ajuste Vis de Calage RP73192 Red/Blue Button Botón–Rojo/Azul Bouton–Rouge/Bleu RP12516 Strap & Screw Barra Chata y Tornillo Feuillard et Vis RP23060 Flange Reborde Collerette RP51502 Cap Casquillo Embase RP6142 Gasket Empaque Joint RP6132 Nut Tuerca Écrou RP6140 Nut & Washer Tuerca y Arandela/ Roldana Écrou et Rondelle RP51503 Bonnet Bonete Chapeau RP12517 Horizon