User Manual

2
User Guide (English)
Introduction
Box Contents
DS1 USB Cable
(4) Stereo RCA Cables Software Download Card
(2) Serato NoiseMap™ Control Vinyl Records User Guide
(2) Serato NoiseMap™ Control CDs Safety & Warranty Manual
Support
For the latest information about this product (system requirements, compatibility information,
etc.) and product registration, visit denondj.com.
Features
1. USB Port: This connection powers DS1 (when your
computer is powered on) and sends to and receives
audio from your computer. Use the included USB
cable to connect this USB port to an available USB
port on your computer.
2. Power Light: This LED lights up when DS1 is
connected to your computer and powered on.
3. Inputs: Use standard stereo RCA cables to connect
these inputs to your audio sources. These inputs can
accept line- or phono-level signals. Use the
Phono/CD Selector to set the proper input level.
4. Phono/CD Selector: Set this switch to match the
levels of the audio sources connected to the inputs.
Use the CD (up) position for line-level CD players
and media players or other line-level audio sources.
Use the Phono (down) position for phono-level
sources such as vinyl turntables.
5. Grounding Terminal: If you’re using phono-level
turntables with a grounding wire, connect the wire
to these terminals. If you experience a low “hum” or
“buzz,” this could mean that your turntables are not
grounded. Please note that some turntables have a
grounding wire built into the RCA connection and,
therefore, nothing needs to be connected to the
grounding terminal.
6. Outputs: Use standard stereo RCA cables to
connect these outputs to your powered speakers or
amplifier system. The main/master mix from your
computer will be sent out of these stereo RCA
outputs.
12
33
66
4
5