Owner's Manual

ENGLISH FRANÇAIS ESPAÑOL PORTUGUÊS ESPAÑOL NEDERLANDS SVENSKA

Connect

Preparation

Carefully check the left (L) and right (R) channels and + (red) and – (black) polarities

on the speakers being connected to the this unit, and be sure to interconnect the

channels and polarities correctly.

NOTE

• Disconnect this unit’s power plug from the

power outlet before connecting the speakers.

Also, turn off the subwoofer.

• Connect so that the speaker cable core wires

do not protrude from the speaker terminal.

The protection circuit may be activated if the

core wires touch the rear panel or if the +

and – sides touch each other (vm page 51

“Protection Circuit”).

• Never touch the speaker terminals while the

power supply is connected. Doing so could

result in electric shock.

• Use speakers with the speaker impedances

shown below.

Speaker terminals

Speaker

impedance

FRONT

6 – 16 ΩCENTER

SURROUND

Connecting the speaker cables

Peel off about 0.03 ft/10 mm of sheathing from

the tip of the speaker cable, then either twist the

core wire tightly or terminate it.

1.AVR1513E3_ENG_IM_GS_00A_0214校了後修正.indd 3 2012/02/14 20:03:30