Operation Manual

- 5 -

Installation

Confirm that the power switch is OFF before you plug the Signal Cables and Power Cords.

To connect the antenna

Connect the antenna or the CATV signal cable directly to the antenna input terminal

located on the back cover, otherwise it will cause inferior image.

Note: 1.Please use 75 ohm coaxial cable.

2.Do not enlace the signal cable and the power cord.

To connect the power

Insert one end of the power cord to the power input terminal located on the

back cover and the other end of the power cord to the power outlet grounding

perfectly.

* The power adopted by this set: AC 240V 50Hz

* When away for a long time, unplug the power plug.

* Do not connect the set to DC power.

Remote control’s batteries installation

This remote control uses 2 x AAA batteries. Remove the back cover as shown, put the

batteries in with the correct (+ and - ).

The batteries should last for approximately 1 year. If the control idles, remove batteries, as

they may leak.

Replace with new batteries:

◆Do not use rechargeable Ni-Cd battery.

◆If it is out of battery, change the two batteries at the same time.

◆Do not use different model (different material) battery.

◆Do not recharge the battery.

Part of the Remote

Control’s back cover

ANT

Part of the TV set’s back cover

Signal cable plug

Power plug

Part of the TV set’s back cover

Power

Off