Instructions / Assembly

TROUBLE SHOOTING
Problem: Faucet leaks from under handle.
Cause: Bonnet is loose or o-ring on cartridge is
dirty or twisted.
Action:
1. Move handle to OFF position. Unscrew the set
screw on the side of the handle seat.
Then remove the entire handle assembly.
2. Tighten the bonnet by turning it clockwise.
Move the cartridge stem to the ON position.
The leak should stop around the cartridge
stem.
3. If the leak does not stop, shut off the water
supply.
Remove the bonnet by turning it counter
clockwise.
Lift out the cartridge valve. Inspect the o-rings.
Clear debris, untwist, or replace if necessary.
4. Replace the cartridge making sure the wings
fit well into the cuts in the faucet body.
Tightly screw the bonnet onto the faucet body.
5. Reinstall the handle.
Problem: Faucet leaks around aerator or an
improper flow pattern.
Cause: Aerator is incorrectly fitted or is dirty.
Action:
1. Unscrew the aerator. Make sure all internal
parts are laying flat.
2. If there is debris, gently flush all parts inside.
3. Reinstall aerator.
Many of these parts come preassembled.
This exploded diagram is to assist in trouble
shooting.
Set Scew
Connect
Inverter
Bonnet
Cartridge
Washer
Mounting Nut
Base Plate
Handle