Installation Guide

17. TROUBLESHOOTING

Problem

Fan will not start.

Fan sounds noisy.

Remote control

malfunction.

Lights shut off and will

not come back on.

Fan wobble.

Solution

1. Check circuit fuses or breakers.

2. Check line wire connections to the fan and switch wire connections in the

switch housing. CAUTION: Make sure main power is off.

3. Check to make sure the dip switches from the transmitter and receiver are

set to the same frequency.

1. Make sure all motor housing screws are snug.

2. Make sure the screws that attach the fan blade bracket to the motor hub is

tight.

3. Make sure wire nut connections are not rubbing against each other or the

interior wall of the switch housing. CAUTION: Make sure main power is off.

4. Allow a 24-hour "breaking-in" period. Most noise associated with a new fan

disappear during this time.

5. If using an optional light kit, make sure the screws securing the glassware

are tight. Check that light bulb is also secure.

6. Do not connect the fan with wall mounted variable speed control(s).

7. Make sure the upper canopy is a short distance from the ceiling. It should

not touch the ceiling.

1. Do not connect the fan with wall mounted variable speed control(s).

2. Make sure the dip switches are set correctly.

1. This unit is equipped with a wattage limiting device. Lamping in excess of

190 watts will disable your ceiling fan's light kit. To reset your light kit you

must turn the power off and re lamp, keeping the wattage under 190 watts.

Restore power to your ceiling fan and continue normal operation.

1. Check that all blade and blade arm screws are secure.

2. Most fan wobbling problems are caused when blade levels are unequal.

Check this level by selecting a point on the ceiling above the tip of one of

the blades. Measure this distance. Rotate the fan until the next blade is

positioned for measurement. Repeat for each blade. The distance deviation

should be equal within 1/8".

3. If the blade wobble is still noticeable, interchanging two adjacent (side by

side) blades can redistribute the weight and possibly result in smoother

operation.

WARNING: TO REDUCE THE RISK OF PERSONAL INJURY, DO NOT

BEND THE BLADE ARM WHILE INSTALLING, BALANCING THE BLADES,

OR CLEANING THE FAN. DO NOT INSERT FOREIGN OBJECTS

BETWEEN ROTATING FAN BLADES.