Instructions / Assembly
SAFETY INSTRUCTIONS FOR SECURITY LIGHT
ALWAYS TURN OFF POWER BEFORE INSTALLING BULB
• When replacing the bulb in this lamp always turn o and give ample time for lamp to cool. Also unplug
lamp from power source. Always close face of lamp securely before turning power back on.
• This lamp is not intended for use nor safe to use in potentially dangerous locations such as places with
explosive or ammable atmospheres.
• Never use around heavy volatile uids such as gasoline.
• This product may cause interference with radios, cordless phones, or devices which use a wireless
remote control, such as televisions. If interference occurs move the product away from the device, plug
the product into a dierent outlet, or move the product out of the line of sight of the remote control.
Complies with part 18 of FCC.
• Use only bulb type and wattage included. Any other bulb may damage unit and create hazard and will
void warranty.
• To avoid electrical shock shut o power at breaker panel before installing or servicing this xture
• Consult local electrical codes for wiring and grounding requirements
• Install only on 120v 60hz circuit
• Mount only on structurally sound material where xture can be securely anchored.
ASSEMBLY
1. Take out all parts of xture from box.
2. Locate acrylic lens. Position acrylic lens so large part of keyhole in metal reector is over screws
in bottom of housing. Holding metal xture housing secure, rotate metal reector counterclockwise
so screws are in smaller part of keyhole. Tighten screws with Phillips screwdriver until snug. Do not
overtighten.
3. Locate bulb. Screw into medium base socket in center of reector. Screw in using base.
DO NOT GRIP BY TUBES. Screw in until snug.
ARM