User guide

Protocol Plus Owner’s Manual ASSEMBLY & SETUP
Version 2 19
Copyright © 2010 by Despatch Industries.
All rights reserved. No part of the contents of this manual may be reproduced, copied or transmitted in any form or by any
means including graphic, electronic, or mechanical methods or photocopying, recording, or information storage and
retrieval systems without the written permission of Despatch Industries, unless for purchaser's personal use.
4.2. MRC5000 Setup (Optional)
O
Refer to instructions provided recorder manufacturer for more
specific installation notes.
Temperature is retransmitted to the MRC5000 recorder from the controller. Set up the
recorder by:
1. Ensure hardware jumper JU1 is in place for the 5 VDC setting (Refer to MRC5000
Manual included).
2. Move Mode to PROG/TEST/CAL to display Prog.
3. Press ▼ twice to display Inps. Move to each Parameter Code using ▼or ▲. Adjust
each Parameter Code using the settings in Table 1.
4. After adjusting all settings, move Mode to RUN. Display on both the Recorder and
controller should read the same.
Figure 6. Protocol Plus Wiring Diagram.