User guide

OPERATION Protocol Plus Owner’s Manual
28 Version 2
Copyright © 2010 by Despatch Industries.
All rights reserved. No part of the contents of this manual may be reproduced, copied or transmitted in any form or by any
means including graphic, electronic, or mechanical methods or photocopying, recording, or information storage and
retrieval systems without the written permission of Despatch Industries, unless for purchaser's personal use.
• Relay 2: End of cycle relay
• Relay 3: Optional N2 purge event
• Relay 4: Optional N2 maintain event
Table 2. Program Page Menu Items and Explanation.
Menu Item
Display
Description
Ramp Time Seg 1
Pro-1 Seg-1 Ramp Time
Ramp time for segment 1 of profile
Event 1 Set Value
3
Pro-1 Seg-1 Ramp Event 1
Event 1 setting for segment 1 ramp of profile
Event 2 Set Value
3
Pro-1 Seg-1 Ramp Event 2
Event 2 setting for segment 1 ramp of profile
Event 3 Set Value
3
Pro-1 Seg-1 Ramp Event 3
Event 3 setting for segment 1 ramp of profile
Event 4 Set Value
3
Pro-1 Seg-1 Ramp Event 4
Event 4 setting for segment 1 ramp of profile
Soak Temp Seg 1
Pro-1 Seg 1 Soak Temp
Soak temperature for segment 1 of profile
Soak Time Seg 1
Pro-1 Seg 1 Soak Time
Soak time for segment 1 of profile
Event 1 Set Value
3
Pro-1 Seg-1 Soak Event 1
Event 1 setting for segment 1 soak of profile
Event 2 Set Value
3
Pro-1 Seg-1 Soak Event 2
Event 2 setting for segment 1 soak of profile
Event 3 Set Value
3
Pro-1 Seg-1 Soak Event 3
Event 3 setting for segment 1 soak of profile
Event 4 Set Value
3
Pro-1 Seg-1 Soak Event 4
Event 4 setting for segment 1 soak of profile
(Repeat for segments 2-8, until ramp = 00:00)
High Limit Setpoint
Profile-1 Hi-Lim SP
High limit setpoint for profile
4
Loop From
Profile-1 Loop From Seg
To start a loop action in a profile
Loop To
Profile-1 Loop To Seg
To end a loop action in a profile
Loop Count
Profile-1 Loop Number
Number of times to execute loop
Profile Link
Profile-1 Link To Pro
To jump from this profile to another
Guaranteed Soak
Profile-1 Guar Band
Guaranteed soak band for profile
3
Available only if optional relay outputs are installed (repeat all for Profiles 2-8).
4
Set to Band to use the high limit band feature.