User guide

PREFACE Protocol Plus Owner’s Manual
4 Version 2
Copyright © 2010 by Despatch Industries.
All rights reserved. No part of the contents of this manual may be reproduced, copied or transmitted in any form or by any
means including graphic, electronic, or mechanical methods or photocopying, recording, or information storage and
retrieval systems without the written permission of Despatch Industries, unless for purchaser's personal use.
5.6.6. Setting Up PID Page ............................................................................. 33
5.6.6.1. Access the PID Page ......................................................................... 33
5.6.6.2. Setting up Auto Tune ........................................................................ 34
5.6.7. Setting up the Control Page .................................................................. 34
5.6.7.1. Access Control Page ......................................................................... 34
5.6.8. Setting up the Communication Page ..................................................... 35
5.6.8.1. Access Communication Page ............................................................ 35
5.6.8.2. Setting up the Real Time Clock Page ................................................ 36
5.6.8.3. Access Real Time Clock Page ........................................................... 36
5.6.9. Setting up the Relay Outputs Page ........................................................ 36
5.6.9.1. Access Relay Outputs Page ............................................................... 37
5.6.10. Setting up the Test Page .................................................................... 38
5.6.10.1. Access Relay Outputs Page ............................................................... 38
5.6.10.2. Setting up the Zone Calibration Page ................................................ 38
5.6.10.3. Access Zone Calibration Page ........................................................... 39
5.6.10.4. Access Factory Calibration Recovery ................................................ 39
5.6.10.5. Adjusting Actual Versus Displayed Parameters................................. 40
5.6.10.6. Setting up the Sensor Calibration Page .............................................. 40
5.6.10.7. Access Sensor Calibration Page ........................................................ 40
5.6.11. Setting up the Enable Page ............................................................... 42
5.6.11.1. Access Enable Page .......................................................................... 42
5.6.12. Setting up Digital Inputs (Optional)................................................... 43
6. Maintenance ...................................................................................................... 45
6.1. Replacement Parts .................................................................................... 45
7. Troubleshooting: Error Messages and Alarm ..................................................... 45
8. Appendices ........................................................................................................ 47
8.1. Quick Reference and Default Values ........................................................ 47
8.1.1. Program Page Default Values ............................................................... 47
8.1.2. Autostart Page Default Values .............................................................. 48
8.1.3. PID Page Default Values ...................................................................... 48
8.1.4. Programming Table Worksheet............................................................. 49
8.1.5. Control Page Default Values ................................................................. 50
8.1.6. Communication (Optional) Page Default Values ................................... 50
8.1.7. Real Time Clock Page Default Values .................................................. 51
8.1.8. Relay Outputs (Optional) Page Default Values ..................................... 52
8.1.9. Test Page Default Values ...................................................................... 53
8.1.10. Zone Cal Page Default Values ........................................................... 53
8.1.11. Sensor Cal Page Default Values ........................................................ 53
8.1.12. Enable Page Default Values .............................................................. 54
8.2. Standard Products Warranty ..................................................................... 55
Figures
Figure 1. Operator Interface. .......................................................................................... 12
Figure 2. Protocol Plus Displays and Control Buttons. ................................................... 14