Manualshelf

User guide

ManualsBrandsDespatch ManualsControl panelProtocol Plus Controller (Heat Only)
41424344454647484950
Protocol Plus Owner’s Manual APPENDICES
Version 2 47
Copyright © 2010 by Despatch Industries.
All rights reserved. No part of the contents of this manual may be reproduced, copied or transmitted in any form or by any
means including graphic, electronic, or mechanical methods or photocopying, recording, or information storage and
retrieval systems without the written permission of Despatch Industries, unless for purchaser's personal use.
8. Appendices
8.1. Quick Reference and Default Values
8.1.1. Program Page Default Values
Table 16. Program Page Default Values.
Menu Item
Display
Default
Range
Setting
Ramp Time Seg
20
Pro-1 Seg-1 Ramp Time
00:00
00m00s to 99h59s
Event 1 Set Value
Pro-1 Seg-1 Ramp Event
Off
Off, On
Event 2 Set Value
Pro-1 Seg-1 Ramp Event
Off
Off, On
Event 3 Set Value
Pro-1 Seg-1 Ramp Event
Off
Off, On
Event 4 Set Value
Pro-1 Seg-1 Ramp Event
Off
Off, On
Soak Temp Seg
Pro-1 Seg 1 Soak Temp
68°F
SPLowerLim to
SPUpperLim
21
Soak Time Seg
Pro-1 Seg 1 Soak Time
00:00
00m00s to 99h59s
Event 1 Set Value
Pro-1 Seg-1 Soak Event
Off
Off, On
Event 2 Set Value
Pro-1 Seg-1 Soak Event
Off
Off, On
Event 3 Set Value
Pro-1 Seg-1 Soak Event
Off
Off, On
Event 4 Set Value
Pro-1 Seg-1 Soak Event
Off
Off, On
(repeat for segments 2-8)
High Limit Setpoint
Pro-1 Hi-Lim SP
Max
HiLimSP
MinHiLimSP to
MaxHiLimSP,
21
Band
22
Loop From
Pro-1 Loop From XX
No
No, Seg-1 to Seg-8
Loop To
Pro-1 Loop To XX
No
No, Seg-1 to Seg-8
Loop Count
Pro-1 Loop Number
0
0 to 99
Profile Link
Pro-1 Link To XX
Stop
Standby
23
, Stop,
Hold, Pro-1 to Pro-8
Guaranteed Soak
Pro-1 Guar Band
Off
Off, 1 to 778°C
(1400°F)
(repeat for profiles 2-8)
20
Cycle Complete LED indication goes ON.
21
See Enable Page (5.6.11)
22
Band value is set on Control Page (5.6.7)
23
If Standby: (1) Cycle Complete LED indication goes ON. (2) Controller beeps if End Of Cycle beep is
enabled. (3) Heater/control output keeps controlling oven temperature at last Soak setpoint. (4) All events
programmed (if relay cards installed and programmed as an event) for the last Soak Segment stays active.