User guide

Protocol Plus Owner’s Manual APPENDICES
Version 2 53
Copyright © 2010 by Despatch Industries.
All rights reserved. No part of the contents of this manual may be reproduced, copied or transmitted in any form or by any
means including graphic, electronic, or mechanical methods or photocopying, recording, or information storage and
retrieval systems without the written permission of Despatch Industries, unless for purchaser's personal use.
8.1.9. Test Page Default Values
Menu Item
Display
Default
Range
Setting
Heater output
Test HeatOut
Off
On
High limit relay
Test HiLimOut
Off
On
Relay 1 output
Test Rly1 Out
Off
On
Relay 2 output
Test Rly2 Out
Off
On
Relay 3 output
Test Rly3 Out
Off
On
Relay 4 output
Test Rly4 Out
Off
On
High Limit Sensor
Test HL Temp
(sensor reading)
8.1.10. Zone Cal Page Default Values
Menu Item
Display
Default
Range
Setting
Zone 1 actual
Zone Cal Zone1Act
38°C
-73°C to 760°C (-100°F to
1400°F)
Zone1 displayed
Zone Cal Zone1Dis
38°C
-73°C to 760°C (-100°F to
1400°F)
Zone 2 actual
Zone Cal Zone2Act
260°C
-73°C to 760°C (-100°F to
1400°F)
Zone2 displayed
Zone Cal Zone2Dis
260°C
-73°C to 760°C (-100°F to
1400°F)
Factory
calibration
31
Zone Cal FactCal
Ready
Ready or Done (push- key)
8.1.11. Sensor Cal Page Default Values
Menu Item
Display
Default
Range
Setting
Control Sensor
Cal
Ctrl Sens 0F
Ctrl Sens 1000F
Ctrl Sens Done
-100°F
1400°F
Done
-100 to 1400°F
-100 to 1400°F
(read only)
HiLim Sensor Cal
HL Sens 0F
HL Sens 1000F
HL Sens Done
-100°F
1400°F
Done
-100 to 1400°F
-100 to 1400°F
(read only)
Retransmit Cal
RetCalLo XXXX
32
32
RetCalHi XXXX
0
4096
0 to 4096
0 to 4096
31
Use only when no calibration instrument is available.
32
The “RetCalLo” and “RetCalHi” values are only change indicators. The actual value is not meaningful.