User Manual

Stackable LCC/LCD Oven Owner’s Manual ASSEMBLY & SETUP
Version 1.1 31
Copyright © 2012 by Despatch Industries.
All rights reserved. No part of the contents of this manual may be reproduced, copied or transmitted in any form or by any
means including graphic, electronic, or mechanical methods or photocopying, recording, or information storage and
retrieval systems without the written permission of Despatch Industries, unless for purchaser's personal use.
3. Pull shelves from the oven and set aside (Figure 11).
4. Loosen the three screws at the upper and lower corners of the right rear of the chamber
(Figure 11).
a. Pull out the shelf support/duct as a single unit and set it aside.
5. Remove the brass nuts and washers from the rods that hold the filter frame in place.
a. Set aside and reuse these nuts to hold the new filter in place.
b. Discard the old filter in accordance with your company’s disposal policies.

Opened pleats in the filter media are normal and result from the
tempering process.
Danger!
Make certain power is disconnected from the oven before
removing or replacing the HEPA filter.
Remove shelves before installing HEPA FILTERS
Loosen three screws to remove the entire inner casing
assembly as a single unit
Loosen ¼ turn using 5/16
inch nut driver
Figure 11. Remove inner casing to install HEPA filter.