Full Product Manual

v.190702 En.11
ENGLISH
SNOW PLOW ASSEMBLY
7. Assemble the D frame (g.9) on top of the A frame (g. 10). With the rounded
portion of the D frame held so it slides under the angle bracket (a, g.10) on top
of the A frame and the centre hole engages the angle locking pin (12, g.10),
connect the two frames using the pivot bolt. This is a 75 mm (2.95”) M6 gr.8 hex
head bolt with a 16 mm washer (8, g.10), inserted from below the hole in the
apex of the “A” of the A frame, through the pivot bolt sleeve. It goes up through
a hole in the centre of the straight side of the “D” in the D frame. Hold this in
place with an M16 Nylock nut. (g.11, below)
8. Attach the main frame to the A frame using the two frame pins (7, g 12). Lock
the pins into the A frame with an M8 x 52 mm gr.8 hex head bolt (42, g 12)
inserted through an 8 mm washer, then the top of the frame at each end and
secured with M8 nylock nuts.
9. If not already attached, bolt the winch to the top of the main frame with 4 M8 x
30 mm gr 8 hex head bolts, 8 mm washers, and M8 Nylock nuts; the bolts being
inserted from the front through the winch base
10. Remove the gr.8 U-bolt from the top of the A frame, attach the lower end of the
winch strap to it and re-attach. The strap should feed over top of the barrel of
the winch toward the front and down to the attachment point on the A frame.
The U-bolt should not be tightened fully. It should have a little play.
11. Align the D frame’s 3 attachment points with the two vertical centre ribs of each
plow blade panel as well as the double, joined vertical ribs in the middle of the
plow (g.13). Insert clevis pins through each attachment point and the vertical
ribs on the back of the blade.