Full Product Manual

En.14 DK2 Avalanche man.
ENGLISH
WINCH / ACTUATOR WIRING DIAGRAM
Red
Black
Red
Red
Black
Black
12 volt
Vehicle Battery
Red
Black
-
+
or
winch
actuator
L
J
N
U
T
S
On Your
Plow
Inside
Your
Vehicle
In the
Engine
Compart-
ment
CAUTION: Before
working on the winch or the
wiring in your vehicle,
disconnect the battery and
any other power sources.
CAUTION: When
securing winch connector
leads to posts be sure to
NOT over tighten nuts as
this will damage winch and
void warranty
NOTE: The 35 amp circuit
breaker is necessary to prevent
possible electrical damage to
either the winch or the vehicle’s
electrical system.
NOTE: Do not connect the
black (negative ground) wire to
the vehicle chassis or bodywork.
It must lead directly to the
negative battery terminal.
NOTE: Mount
the control box
securely, away
from moving parts
and sources of
heat.
NOTE: Apply electrical contact
grease to all connections to
prevent corrosion
NOTE: An actuator (below)
may be subbed instead of the
winch (shown above).
IN = raise blade
OUT = lower blade