Replacement Part List

OPERATION – BEFORE TURNING KEY AND PULL STARTING ENGINE
CLEAR AREA OF ALL PEOPLE AND PROPERTY THAT COULD BE DAMAGED. THINK
SAFETY. CHIPS ARE FLYING PROJECTILES AND CAN CAUSE INJURY.
WEAR SAFETY GLASSES, HEARING PROTECTION, AND GLOVES
DO NOT WEAR LOOSE FITTING CLOTHES THAT COULD GET STUCK IN THE MACHINE
MOVING PARTS, ONLY CHIP WOOD, CHILDREN SHOULD NOT RUN THIS EQUIPMENT,
STAY ALERT OF YOUR SURROUNDING AND PERSONS THAT COULD APEAR IN THE
CHIP PATH WHILE YOU ARE WORKING.
UNIT IS A DIRECT DUAL BELT DRIVE. NO CLUTCH
TO SLIP OR BURN UP
BUT YOUR BELTS WILL NEED TIGHTENED AND CHECKED ON A REGULAR BASIS TO
MAINTAIN 100% CUTTING POWER.
• Tip the Stump Grinder up with the cutters off the ground when pull starting.
9 CARBIDE CUTTERS. AN EXTRA SET IS PROVIDED WITH YOUR PURCHASE AS A
THANK YOU FOR CHOOSING DK2 POWER.
PERFORMANCE OPERATION -
APPROACH STUMP FROM THE TOP CUTTING STRAIGHT DOWN INTO THE STUMP
WITH THE 3.5 INCH WIDE CUTTING TEETH. RAISE UP OUT OF THE CUT, MOVE
OVER, PLUNGE AGAIN. REPEAT ACROSS ENTIRE STUMP. MOVE SIDE TO SIDE TO
FACE OFF THE STUMP. ADJUST YOUR BOW HANDLE FOR COMFORT.
SET ONE OF YOUR WHEEL BRAKES SO YOU CAN PIVOT THE MACHINE CUT.
TO MOVE THE MACHINE FORWARD WITH THE BRAKE ON, ALLOW THE ROTATING
TEETH AGAINST THE STUMP TO PULL THE UNIT FORWARD.
TIGHTEN ALL BOLTS AND TEETH BEFORE EACH USE. TEETH ARE NOT COVERED
UNDER WARRANTY. CLEAN ALL STONES AND ROCKS AWAYS FROM CUTTING STUMP
AREA, CHECK FOR METAL STAKES AND OR NAILS IN THE TREE STUMP BEFORE
CUTTING.
KOHLER ENGINES HAVE A LOW OIL SHUTOFF TO PROTECT THE ENGINE, TILTING THE
GRINDER HIGHER THAN 12 INCHES AT AN ANGLE CAN CAUSE THE OIL TO ROLL BACK
AND THE LOW OIL SENSOR WILL SHUT THE ENGINE OFF. CUT YOUR STUMP 9 TO 10
INCHES OFF THE GROUND SO YOU DON’T TRIP THE SENSOR ON THE ENGINE.
READ AND OBEY ALL WARNING LABELS ON THIS MACHINE.