Owner's manual

Installation
Hanger Plate Location for Single Pull Units
Thehangerplateshouldbelocated5/8"fromtheoutsideedgeofthehingejamb,(typical13/4”
frameface)leveland1-1/16”abovebottomofthedoorframe.Thegoalistobeabletopassthe
doorunderthemainshaftofthemotor.Barclampthehangerplate.Usinghangerplatemarkand
drillholesintotheheaderframeorsolidwallorwallstud.Fastenusingappropriatetypeandsize
screws(Detexrecommendsusingatheadtype).
Note:Drillingdebrisaccumulatedinhangergroovetrackscanpreventtheoperatorfromseat-
inguniformlywhenmounting.Removedebriswiththinbrush.Maskingtapecanalsobeusedto
preventdebrisfromcollectingingroove.
Lifttheoperatorandlowerontothewebsofthehangerplatebracket.Besurebothtopand
bottomareengaged.
104851Page4
SECURE HANGER WITH SCREWS
HINGED SIDE
5/8”
1-1/16”
HangerPlate
Oncetheyareseated,pulldownuntilunitiscompletelyushandscrewscanbereplacedintop
corners.
Replace
Screw
here
Replace
Screw
here