Operation Manual

27
E N G L I S H
- Risk of squeezing fingers when changing the
accessory.
- Health hazards caused by breathing dust
developed when working in concrete and/or
masonry.
Package contents
The package contains:
1 Heavy duty rotary hammer drill
1 Side handle
1 Depth adjustment rod
1 Kitbox
1 Keyless chuck (D25314K)
1 Instruction manual
1 Exploded drawing
● Check for damage to the tool, parts or
accessories which may have occurred during
transport.
● Take the time to thoroughly read and
understand this manual prior to operation.
Description (fig. A)
Your D25313K/D25314K rotary hammer has been
designed for professional hammer drilling and light
chipping, chiselling and demolition applications and
for carbide tipped core drilling in concrete, brick
and stone. The machine is also suitable for rotary
drilling in wood, metal, ceramic and plastic and for
screw driving and thread cutting.
1 Variable speed switch
2 Forward/reverse slider
3 Mode selector
4 Safety lock
5 Tool holder
6 Dust cover
7 Locking collar (D25314K)
8 Depth adjustment rod
9 Side handle
10 Depth stop clamp
Torque limiting clutch
All rotary hammer drills are equipped with a torque
limiting clutch that reduces the maximum torque
reaction transmitted to the operator in case of
jamming of a drill bit. This feature also prevents the
gearing and electric motor from stalling.
The torque limiting clutch has been factory-set and
cannot be adjusted.
Electrical safety
The electric motor has been designed for one
voltage only. Always check that the power supply
corresponds to the voltage on the rating plate.
#
Your DEWALT tool is double insulated in
accordance with EN 60745-1; therefore
no earth wire is required.
@
115 V units have to be operated via a
failsafe isolating transformer with an
earth screen between the primary and
secondary winding.
Mains plug replacement
(U.K. & Ireland only)
● Should your mains plug need replacing and you
are competent to do this, proceed as instructed
below. If you are in doubt, contact an authorized
DEWALT repair agent or a qualified electrician.
● Disconnect the plug from the supply.
● Cut off the plug and dispose of it safely; a plug
with bared copper conductors is dangerous if
engaged in a live socket outlet.
● Only fit 13 Amperes BS1363A approved plugs
fitted with the correctly rated fuse (1).
● The cable wire colours, or a letter, will be
marked at the connection points of most good
quality plugs. Attach the wires to their
respective points in the plug (see below). Brown
is for Live (L) (2) and Blue is for Neutral (N) (4).
● Before replacing the top cover of the mains plug
ensure that the cable restraint (3) is holding the
outer sheath of the cable firmly and that the two
leads are correctly fixed at the terminal screws.
!
Never use a light socket.
Never connect the live (L) or neutral (N)
wires to the earth pin marked E or .