Instruction manual

4
English
work in a well ventilated area, and work with approved safety
equipment, such as those dust masks that are specially designed
to filter out microscopic particles.
• Avoid prolonged contact with dust from power sanding,
sawing, grinding, drilling, and other construction activities.
Wear protective clothing and wash exposed areas with
soap and water. Allowing dust to get into your mouth, eyes, or
lay on the skin may promote absorption of harmful chemicals.
WARNING: Use of this tool can generate and/or disburse dust,
which may cause serious and permanent respiratory or other injury.
Always use NIOSH/OSHA approved respiratory protection
appropriate for the dust exposure. Direct particles away from face
and body.
WARNING: ALWAYS USE SAFETY GLASSES. Everyday
eyeglasses are NOT safety glasses. Also use face or dust mask if
cutting operation is dusty. All users and bystanders MUST ALWAYS
wear certified safety equipment:
• ANSI Z87.1 eye protection (CAN/CSA Z94.3),
• ANSI S12.6 (S3.19) hearing protection,
• NIOSH/OSHA/MSHA respiratory protection.
WARNING: Wear appropriate hearing protection during use.
Under some conditions and duration of use, noise from this product
may contribute to hearing loss.
• The label on your tool may include the following symbols. The
symbols and their definitions are as follows:
V ...........volts A ........ amperes
Hz .........hertz W....... watts
min ........ minutes
..... alternating current
......direct current ..... alternating or direct current
.......... Class I Construction
n
o ...... no load speed
.............. (grounded) ...... earthing terminal
..........Class II Construction ...... safety alert symbol
.............. (double insulated) BPM .. beats per minute
…/min ...per minute RPM .. revolutions per minute
IPM ....... impact per minute
DESCRIPTION (FIG. 1)
WARNING: Never modify the power tool or any part of it.
Damage or personal injury could result.
FIG. 1
A
C
B
D
A. Side handle C. Main handle
B. Switch D. Tool sleeve
INTENDED USE
This demolition hammer is designed for professional light or medium
chipping, chiselling and demolition applications in concrete, brick
and masonry.
DO NOT use under wet conditions or in presence of flammable
liquids or gases.