User Guide

1. Loosen both cutting die cap screws (K) counterclockwise using

the hex wrench (E) provided.

2. If your desired thread cutting size is overly worn, replace both with

a new cutting die set.

3. Position the cutting dies so that both stationary cutting die and

moveable cutting die are aligned with same thread size.

NOTE: Ensure that the dots on the cutting dies are facing toward

each other and they are seated against the two perpendicular

surfaces of the stationary cutting die (C) jaw and moveable cutting

die (D) jawbefore tightening.

4. Tighten cutting die cap screws (K) clockwise using the hex

wrench (E).

5. Install a battery and cycle the tool to ensure proper assembly and

alignment prior to making a cut.

CAUTION: If the cutting die cap screws or hex wrench are lost or

damaged replace with identical replacement parts. Recommended

replacement parts for use with your tool are available at extra cost

from your local dealer or authorized service center. Always use

identical replacement parts

FIG. 3

OPERATION

WARNING: To reduce the risk of serious personal injury,

turn tool off and remove the battery pack before making any

adjustments or removing/installing attachments or accessories.

An accidental start-up can cause injury.

WARNING: Cut Hazard. NEVER have any part of your body

near the cutters. Serious personal injury may occur.

WARNING: Cut Hazard. To reduce the risk of serious

personal injury, DO NOT use the threaded rod cutter with any

kind of accessory or attachment other than those recommended by

DeWALT

WARNING: Cut Hazard. Wear gloves when handling threaded

rod. The ends and threads can be sharp and can cause serious

personal injury.

Installing and Removing the Battery Pack

(Fig. 4)

NOTE: For best results, make sure your battery pack is fully charged.

To install the battery pack (G) into the tool handle, align the battery

pack with the rails inside the tool’s handle and slide it into the handle

until the battery pack is firmly seated in the tool and ensure that it

does not disengage.

To remove the battery pack from the tool, press the release button (H)

and firmly pull the battery pack out of the tool handle. Insert it into the

charger as described in the charger section of this manual.

English