Use and Care Manual

16
English
band saw blade. To obtain maximum service life of the band saw
blade, ensure there is no sudden impact at the beginning of the
cutting operation.
4. As shown in Figure 11,
FIG. 11
straight cutting can be
accomplished by keeping
the band saw blade
aligned with the side
surface of the motor
housing. Any twisting or
cocking of the blade will
cause the cut to go offline
and decrease the life of
the blade.
NOTICE: During cutting,
if the band saw becomes
locked or jammed in the
workpiece material, release
the switch immediately to
avoid damage to the band saw blade and motor.
5. The tool’s own weight provides the most efficient downward
cutting pressure. Added operator pressure slows the blade and
reduces blade life.
6. End pieces, which would be heavy enough to cause injury when
they drop, after cut-off, should be supported. Safety shoes are
strongly recommended. End pieces may be hot and sharp.
7. Whenever possible, hold the saw firmly in both hands.
8. DO NOT MAKE ANY SPEED CHANGES UNLESS TOOL HAS
BEEN TURNED OFF.
FIG. 12
YES
NO
RECOMMENDED CUTTING POSITIONS
YES
YESYES
YES
YES
NO
NO
NO
NO
NO
Tips for Better Cutting
The following recommendations should be used as a guide (refer
to Figure 12). Results may vary with the operator and the particular
material being cut.