Use and Care Manual
ENGLISH
10
12. Line up the white nubs
22
inside the spool housing
with the recesses
28
of the spool. Align the holding
slots
24
with the two holes
27
as close as possible.
13. Push the spool into the spool housing and turn
counterclockwise to lock the spool in place. Ensure the
white nub
22
appears in the spool window
21
. Make
sure the line doesn't unravel and wrap around the shaft
below the spool.
14. Pull both ends of the cutting line to release them from
the holding slots. If the line extends past the cutting blade
on the guard cut the line so it just reaches the blade.
fig. M
27
22
28
Replacing Spool Housing (Fig. N, O)
1. Rotate the spool housing
11
until the hole
29
in the
spindle
30
lines up with notch
31
in the guard
10
.
A third hole in the motor housing
32
will be visible as
shown in figureN. Insert screwdriver through each all
three holes to prevent the spool housing from turning.
2. Turn the spool housing clockwise as shown in figureO.
3. Insert a screwdriver back through the three holes
(
29
,
31
, and
32
) and thread the new spool housing
counterclockwise and securely tighten onto the bolt
33
protruding from the trimmer.
fig. N
30
29
32
31
fig. O
33
Replacing Guard (Fig. P, Q)
WARNING: Never operate appliance without guard
firmly in place. Damage or personal injury could result.
1. Remove the spool housing as described in the
"Replacing Spool Housing" section.
2. Remove the 4 guard screws
34
shown in figureP.
3. Lift the guard off at an angle as shown in figureQ.
fig. P
34
34
fig. Q
4. To attached a new guard, slide the tab
35
of the new
guard under the lip
36
of the motor housing
6
, then
lower the back of the guard into place as shown in
figureR.
5. Replace and securely tighten the 4 guard screws
34
.
6. Replace the spool housing as described in the
"Replacing Spool Housing" section.
fig. R
36
35
Repairs
The charger and battery pack are notserviceable.
WARNING: To assure product SAFETY and
RELIABILITY, repairs, maintenance and adjustment
(including brush inspection and replacement) should
be performed by a
DeWALT factory service center
or a DeWALT authorized service center. Always use
identical replacementparts.
Register Online
Thank you for your purchase. Register your product nowfor:
• WARRANTY SERVICE: Registering your product will
help you obtain more efficient warranty service in case
there is a problem with yourproduct.
• CONFIRMATION OF OWNERSHIP: In case of
an insurance loss, such as fire, flood or theft, your
registration of ownership will serve as your proof
ofpurchase.
• FOR YOUR SAFETY: Registering your product will
allow us to contact you in the unlikely event a safety
notification is required under the Federal Consumer
SafetyAct.