Instruction manual

4
English
4
2. With blade wrench, loosen and remove the blade bolt by turning
it in a counterclockwise direction when facing blade (right hand
thread). Retract lower blade guard and remove blade.
3. When mounting new blade, the teeth must point in the direction of
blade rotation. Replace outer clamp washer. Replace and tighten
the blade bolt as much as possible with the fingers, then tighten
firmly with the blade wrench.
CUTTING DEPTH ADJUSTMENT (FIG. 4-6)
DISCONNECT PLUG FROM POWER SUPPLY.
Hold the saw firmly. Raise the depth adjustment lever Figure 4 (B) to
loosen and move shoe to obtain the desired depth of cut, as shown.
Make sure the depth adjustment lever has been retightened (lowered)
before operating saw.
Your saw is equipped with a carbide tipped saw blade for long life and
efficient cutting.
Setting the saw at the proper cutting depth keeps blade friction to a
minimum, removes sawdust from between the blade teeth, results in
cooler, faster sawing and reduces the chance of kickback. Align the
appropriate mark on the depth adjustment strap with triangle on the
upper blade guard.(Fig. 4)(A) Your depth is set.
For the most efficient cutting action using a carbide tipped saw blade,
set the Depth Adjustment so that about one half of a tooth projects
below the surface of the wood to be cut (Figure 5).
A method of checking for the correct cutting depth is shown in Figure
6. Lay a piece of the material you plan to cut along the side of the
blade, as shown in the figure, and observe how much tooth projects
beyond the material.
BEVEL ANGLE ADJUSTMENT (FIG. 7)
DISCONNECT THE SAW FROM THE POWER SUPPLY
The full range of bevel adjustment is from 0 to 56 degrees. The pivot
bracket is graduated in increments of 1 degree.
On the front of the saw is a bevel angle adjustment mechanism
consisting of a quadrant with a pointer (B) and a lever (A).
FIG. 1
FIG. 2
FIG. 3
A