Datasheet

2-46
Dialight Corporation • 1501 Route 34 South • Farmingdale, NJ 07727 • TEL: [phone] • FAX: [phone] •www.dialight.com
5mm Round
®
Optopipe
TM
Optical Light Pipe, 3 Array
515-1010
4.83
[.190]
4.83
Ø [.190]
5.16
[.203]
5.16
[.203]
1.14
[.045]
12.7
[.500]
17.86
[.703]
PIN
MOUNTING
HOLE
Ø [.113 ± .002]
1.65
[.065]
2.41
[.095]
14.6
[.575]
NOTE:
C. L. of LED
4.14
[.163]
RECOMMENDED SOLDER PAD/HOLES LAYOUT
DIFFUSED
FRONT
SURFACES
DIRECTION
OF LIGHT
3.94
[.155
]
12.7
[.500]
12.7
[.500]
2.41
[.095]
6.3
[.250]
6.35
[.250]
8.76
[.345]
2.95
[.116] TYP;
(2) PLACES
2.84
[.112]
6.35
[.250]
6.35
[.250]
11.30
[.445]
Dimensions in mm [inches]
NOTE: designed for
post-reflow
PC board insertion.
Recommended
MicroLED SMT LEDs
for use with 515-1010
PART NO. COLOR PAGE #
597-3001-2xx Red 1-21
597-3111-5xx AlGaAs Red 1-30
597-3121-2xx AlGaAs Red 1-21
597-3211-2xx Orange 1-21
597-3211-5xx Orange 1-30
597-3301-2xx Green 1-21
597-3301-5xx Green 1-30
597-3401-2xx Yellow 1-21
597-3401-5xx Yellow 1-30
597-7701-2xx Red/Green 1-23
597-7701-5xx Red/Green 1-31
597-7721-2xx Yellow/Green 1-23
597-7721-5xx Yellow/Green 1-31
597-7731-2xx Red/Yellow 1-24
Features
• High transmissivity polycarbonate material
• UL94V-0 compliance
• ESD protection (circuit isolation from front panel)
• Wide viewing angle
• Arrays reduce insertion costs
• Designed to replace 5mm right angle through-hole device
• Compatible with Dialight’s 515-1011 single position Optopipe
Light Pipe
• Secures to PCB by press-fit
LED Data
For absolute maximum ratings and other
electrical and optical data on the recommended
LEDs, refer to LED data sheets.
Dialight Optopipe Light Pipe Description
This light pipe’s larger light emitting surfaces appear bright and are optically well isolated. It is reliably held in place by
2 press-fit pins located between the light pipe elements. This Optopipe™ functions as a through-the-case indicator with a
textured finish on the 3 light emitting surfaces that increases its viewing angle. The recommended light sources are
Dialight's 597 Series PLCC-2 or PLCC-4 Type SMT LEDs. The LEDs are mounted in a straight line on a 0.500" pitch. The
light pipe material is water clear transmissive polycarbonate rated UL94-V0, and has a 35% oxygen index.
Dialight can provide custom Optopipe™ solutions for your applications.
Operating/Storage Temperature
–30°C to +100°C