PBX Integration Board User's Guide

Dialogic
®
PBX Integration Board User’s Guide
Line Key 1
00 0F 00 00 00 00 00 00 00 00 00 00 00 00 00 00 xx 00 00 00 xx 00 00 00
00 01 02 03 04 05 06 07 08 09 10 11 12 13 14 15 16 17 18 19 20 21 22 23
00 00 xx xx xx xx xx xx xx xx xx xx xx xx xx xx xx xx xx xx xx xx xx xx
24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47
Line Key 2 Line Key 3 Line Key 4 Line Key 5 Line Key 6 Line Key 7 Line Key 8 Line Key 9 Line Key 10 Line Key 11 Line Key 12 Line Key 13 Line Key 14 Line Key 15 Line Key 16 Not Used MWI CNF Key FCN Key Not Used LNR/SPD Key ANS Key SPKR Key
Data
Byte
Data
Byte
ICM MIC
NOTE: Bit 3 determines if the indicator is red or green. If bit 3 is 0, the
indicator is red; if bit 3 is 1, the indicator is green.
The example below shows the binary data for On and Wink.
Bit Hex 7 6 5 4 3 2 1 0
On 0x7 (red) 0 1 1 1 x x x x
On 0xF (green) 1 1 1 1 x x x x
Wink 0x2 (red) 0 0 1 0 x x x x
Wink 0xA (green) 1 0 1 0 x x x x
Pressing Flexible Line Keys
The Dialogic
®
PBX Integration Board can “press” any of its Flexible Line
keys using the dx_dial( ) function. Refer to the Dialogic
®
PBX Integration
Software Reference for more information about dialing keys. Each Flexible
Line key on the DTerm Series III telephone is assigned a dial string sequence
(refer to
Table 36). By using the dx_dial( ) function and the appropriate dial
string, the PBX Integration Board can press any Flexible Line key.
156