User`s guide

Dialogic
®
System Release 6.0 PCI for Windows
®
Release Update, Rev 62 — January 30, 2008 107
Dialogic Corporation
file (other than the default value) to all trunks on the board, highlight PDKTrunk 0.
Otherwise proceed to step 4.
3a. From the Variant drop-down menu, select a CDP variant file by highlighting the file
and clicking the Set button.
Note: If you wish to remove a previously assigned CDP variant file, highlight the
variant under that trunk in the window and click the Remove button.
3b. Repeat this step for each additional CDP variant file you wish to assign to all of the
trunks on this board.
Note: When multiple CDP file variants are assigned to a trunk, an application can
dynamically change variants on that trunk. In this case, for a given trunk, it is
the last variant in the list that is taken as the default. For example, if one looks
at a given trunk in the DCM/PDK Configuration window and sees a list:
PDKTrunk#
pdk_ar_r2_io.cdp
pdk_cn_r2_io.cdp
pdk_be_r2_io.cdp
Then, the “pdk_be_r2_io.cdp” will be taken as the default.
3c. Click the Apply button and then click the OK button to return to the DCM main
window.
4. If not all trunks on the board have been configured for CAS or R2MF, or if you wish to
assign different CDP variant files to individual trunks on a trunk-by-trunk basis:
4a. Highlight the trunk to which you wish to assign a CDP variant file.
4b. Choose a CDP variant file from the Variant drop-down list and click the Set button.
Note: If you wish to remove a previously assigned CDP variant file, highlight the
variant under that trunk in the window and click the Remove button.
4c. Repeat steps 4a and 4b for each trunk on the board that you wish to assign CDP
variant files.
4d. Click the Apply button and then click the OK button to return to the DCM main
window.
See the Dialogic
®
Global Call Country Dependent Parameters (CDP) for PDK Protocols
Configuration Guide for information about configuring the parameters contained in an
individual CDP file.
The protocol package is included with the system software.
1.35.2 Automatic FCD File Generation
With the Service Update, the fcdgen utility is no longer required to generate the FCD file.
When you download a PCD file and its corresponding CONFIG file to a board, the FCD
file is automatically generated and also downloaded to the board. The FCD file is also
copied into the data directory.
With this enhancement to the configuration process, it is no longer necessary to use the
fcdgen utility to generate a modified FCD file. When you modify a CONFIG file, the