User`s guide

Dialogic
®
System Release 6.0 PCI for Windows
®
Release Update, Rev 62 — January 30, 2008 115
Dialogic Corporation
Some examples of commands that can be included in a dm3enum.cfg file are:
board 0
b 1
board (1 3)
b (1 3)
The feature generates a number of log files in the Dialogic\log directory:
Dm3enumreate.log
Log file for application that starts dynamic protocol configuration enablement
Protocol_enmurate_board_#.log
Log file of actual dynamic protocol configuration enablement process for boards that
use non-PDK protocols
Pdkenumerate.log_board#
Log file of actual dynamic protocol configuration enablement process for boards that
use PDK protocols
Enabling Protocol Configuration
To enable protocol configuration for PDK protocols, after running the pdkmanagersetup
add
command, run the following command:
pdkmanagerregsetup enumerate
Then,
• Download the board firmware.
• Run the devmapdump utility to check that the protocol information has been loaded
(search for CDP_ and CAS_ parameters). If this is not the case, run the
dm3enumerate utility to load the protocol information manually after each firmware
download.
To enable protocol configuration for non-PDK protocols, run the
dm3enumerate utility to
load protocol name information.
1.42.1.2 Retrieving a Protocol ID
DM3 protocol names have the format “lb#pv#:Variant_Name”, where:
• lb# is the logical board ID on a physical DM3 Board
• pv# is the protocol variant ID
Some examples are:
• “lb1pv1:pdk_us_mf_io” - A PDK protocol that is the first protocol variant on logical
board 1
• “lb2pv1:isdn_net5” - An ISDN Net5 protocol that is the first protocol variant on logical
board 2