User`s guide

Dialogic

System Release 6.0 PCI for Windows

Release Update, Rev 62 — January 30, 2008 145

Dialogic Corporation

The #0 and #1 represent the logical ID or board ID. The slot 1/11 and slot 2/3 represent

the bus and slot numbers, which identify the unique location of the boards. See the

following valid values for the Name and Type parameters.

Warning: Do not change the board Name or Type. The optimum settings are specific to the

category of board (board name and architecture type). The values for these parameters

are only shown to help you identify specific boards.

Valid DM3 Board names for Name parameter:

• DI/0408-LS-A-R2

• DMV160LP

Valid Springware Board names for Name parameter:

• D/41JCTls

• D/120JCT-LS-Rev 2

Valid values for Type parameter:

• DM3

• Springware

Channel Identification

The Channel number keyword identifies the channel on the board. The channel

identification line is followed by the optimum coefficient settings that apply to the channel.

The format of the channel identification line is shown through the following example:

This specifies channel number 1.

Note: Do not attempt to edit the optimum coefficient values.

Terminator for End of Board Data Section

Each board section is terminated by an end-board line as follows:

</BOARD>

1.43.5 LineAdapt Utility Command Line Interface

For the location of the utility program executable and its files, see Section 1.43.4.1,

“Location and Description of the Utility and Component Files”, on page 139.

This section provides information on the following topics:

• Prompting Mode and Command Mode

• Discovery, Initialization, and Storage of Optimum Settings