User`s guide

Dialogic
®
System Release 6.0 PCI for Windows
®
Release Update, Rev 62 — January 30, 2008 149
Dialogic Corporation
channel numbers on the board). If channel targets are not specified (i.e., if the -c
parameter is not used), the default is all channels on the board. Syntax example:
LineAdapt -b0 -s1 -c1 -c2 -c8-12
This command adapts channels 1 and 2 and channels 8 through 12 on the target
board in bus 0, slot 1. The command performs discovery on the specified targets,
stores the optimum coefficients in the LineAdaptOptCoef.xml file for initialization with
future downloads, and initializes the boards with the settings.
-d <dial string>
Specifies a valid dial string to connect to a known silent termination when the utility
takes the channel off-hook to perform testing. If not specified, the default is DTMF
digit 3, which is used to silence the dial tone. Alternatively, another DTMF digit can be
specified in the dial string to silence the dial tone (e.g., LineAdapt -d5). The -d
parameter can also be used in Prompting Mode.
-h
Displays online help showing all the possible command line arguments. This
parameter is not used with any other parameters (it is a stand-alone parameter), but if
any other parameters are specified, it takes precedence over them.
-l
Lists board information for supported and recognized (started) boards, including the
bus number, slot number, and channels. This parameter is not used with any other
parameters (it is a stand-alone parameter).
-n [ -DM3 | -Springware ]
Specifies no discovery (and thus also no storage). This parameter uses the current
configuration in the LineAdaptOptCoef.xml file to initialize the boards with their
optimum coefficients. Since this parameter requires optimum settings in the
LineAdaptOptCoef.xml file, the utility must have been executed previously for
discovery and storage of optimum settings. This parameter is used internally by DCM
in the download or system startup sequence, although it can be used independently
of it as well. To initialize only DM3 Boards, specify LineAdapt -n -DM3; or to initialize
only Springware Boards, specify LineAdapt -n -Springware; otherwise the -n
parameter applies to all board types. The -n parameter is mutually exclusive with the
-b, -s, and -c parameters, which perform discovery on target boards and channels,
and with the -a parameter, which performs discovery on all applicable boards.
-r
Removes (deletes) the LineAdaptOptCoef.xml file, which restores the default
configuration for channel impedance (no gain) which existed prior to any adaptation.
That is, the boards will be downloaded with the default coefficients from the CONFIG
or PRM file. This parameter is not used with any other parameters (it is a stand-alone
parameter).
-s <slot number>
Specifies the slot number in the chassis where the target board resides. Must be used
with the -b parameter (see the -b parameter description for details).
-t
Specifies temporary discovery and initialization. With this parameter, the optimum
coefficients found out are not stored in the LineAdaptOptCoef.xml file, although
summary information is recorded in the LineAdapt.log file. The optimum settings