User`s guide

Dialogic
®
System Release 6.0 PCI for Windows
®
Release Update, Rev 62 — January 30, 2008 155
Dialogic Corporation
di0408lsa_REV2_ML3.config. See the Dialogic
®
DM3 Architecture PCI Products on
Windows
®
Configuration Guide for more information about media loads and configuration
file sets.
There are five media loads for the DI0408LSAR2 Board. The feature sets available in
each media load are described below:
Media Load 1
Media load 1 provides the following features:
• Trunks: call control, caller ID, and dedicated voice (player, recorder, tone
generator, signal detector) for the four analog loop start interfaces
• Stations: call control, caller ID, and dedicated voice (player, recorder, tone
generator, signal detector) for the eight analog station interfaces
• Capability to switch the signal from the audio input to the CT Bus/SCbus
• Support for up to three conferences with a total of nine parties max between all
conferences. Conference resources are shareable across the system via the CT
Bus/SCbus. The ability to bridge conference resources for larger conferences is
supported; see Section 1.54, “Conference Bridging on Dialogic
®
DI Boards”, on
page 221.
• Two channels of V.17 fax shareable across the system via the CT Bus/SCbus
Media Load 2
Media load 2 provides the following features:
• Eight channels of voice (player, recorder, tone generator, signal detector)
shareable across the system via the CT Bus/SCbus
• Trunks: call control, caller ID, and dedicated tone generation and signal detection
capability for the four analog loop start interfaces
• Stations: call control, caller ID, and dedicated tone generation and signal
detection capability for the eight analog station interfaces
• Capability to switch the signal from the audio input to the CT Bus/SCbus
• Support for up to three conferences with a total of nine parties max between all
conferences. Conference resources are shareable across the system via the CT
Bus/SCbus. The ability to bridge conference resources for larger conferences is
supported; see Section 1.54, “Conference Bridging on Dialogic
®
DI Boards”, on
page 221.
• Two channels of V.17 fax shareable across the system via the CT Bus/SCbus
Media Load 3
Media load 3 provides the same features as media load 2 with the addition of:
• Four channels of IP telephony shareable across the system via the CT
Bus/SCbus
Media Load 4
Media load 4 provides the same features as media load 2 with the addition of:
• Four channels of continuous speech processing (CSP)
Media Load 5
Media load 5 provides the following features: