User`s guide

Dialogic
®
System Release 6.0 PCI for Windows
®
Release Update, Rev 62 — January 30, 2008 157
Dialogic Corporation
– For media load 3: dxxxB6C1 and dxxxB6C2
– For media load 4: dxxxB7C1 and dxxxB7C2
Application control is provided by the fx_ APIs.
• For media load 3 only: the four channels of IP are designated as follows:
– For IPT network devices: iptB1T1-iptB1T4
– For IP media devices: ipmB1C1-ipmB1C4
– For multiple DI0408LSAR2 Board configurations:
• board 2: IPT network devices: iptB1T5-iptB1T8; IP media devices: ipmB2C1-
ipmB2C4
• board 3: IPT network devices: iptB1T9-iptB1T12; IP media devices:
ipmB3C1-ipmB3C4
• ...
• For media load 5 only: the 12 channels of IP are designated as follows:
– For IPT network devices: iptB1T1-iptB1T12
– For IP media devices: ipmB1C1-ipmB1C12
• For media load 4 only: the four channels of continuous speech processing (CSP) are
enumerated as dxxB6C1-dxxB6C4. Application control is provided by the ec_ APIs.
1.45.2 Configuring the Software
This section contains information about configuring IP parameters on DI0408LSAR2
Boards; this information supplements the configuration information in the Dialogic
®
DM3
Architecture PCI Products on Windows
®
Configuration Guide.
Selecting a Firmware File
The first time you run the Dialogic
®
Configuration Manager (DCM) with a DM3 Board in
your system, you are prompted to select the firmware files (PCD and FCD) to be
downloaded to each board. As discussed above in the DI0408LSAR2 Media Loads
section, the PCD/FCD files determine the media load supported by the board.
DCM displays a list of PCD files. Select the PCD file for the media load that you want, for
example, di0408lsa_REV2_ML3.pcd for media load 3. The selected PCD file and
corresponding FCD file will be downloaded when the boards are started.
Setting the ToS Parameter in DCM
With this release, a new parameter for enabling or disabling ToS has been added to DCM
for DI0408LSAR2 Boards. The parameter is called DI_TOS and it appears on the Misc
property sheet. The default value for DI_TOS is Enable. If DI_TOS is set to Disable, the IP
Media Service disables ToS processing for RTP packets transmitted from IP Media
channels. In this configuration, all RTP packets transmitted from DI0408LSAR2 Board IP
Media channels will have the ToS field in their IP packet header set to zero.