User`s guide

Dialogic
®
System Release 6.0 PCI for Windows
®
Release Update, Rev 62 — January 30, 2008 275
Dialogic Corporation
Known IPY00007510 32342 Host Admin CTBB event logs are being made without descriptions
appearing in the Application log panel. CTBB event
logs should not even appear in the Application log
panel. CTBB event logs should only appear in the
System log panel with descriptions.
Known IPY00006547 33730 Host Admin After the initial install, DCM detects boards in a
different order after Restore Device Defaults is run.
Known IPY00006036 31669 Host Admin Using Terminal Server to control a GDK machine is
not supported. If needed, remote access to a GDK
machine can be easily done through other means (e.g.
remote desktop connection using XP, Netop, etc).
Workaround: Don't use remote access to the GDK
machine. It is not a requirement to run a demo on a
GDK machine remotely (through Terminal Server).
Known IPY00006011 31701 Host Admin When using the Event service consumer object to
subscribe for events, sometimes the application hangs
while exiting on Windows
®
XP systems.
Workaround: A sleep of 1 second at the end of the
application causes this hang to go away.
Known IPY00005982 31435 Host Admin dlgsnapshot utility is not functional on Dialogic
®
DM/V-
B Boards.
Known IPY00024819 31099 Host Install When uninstalling the Dialogic
®
Software, a warning
message stating “Error encountered after attempting
to launch” may appear if an error was encountered
after the setup program attempted to launch a utility.
Workaround: Follow these steps if you encounter this
error:
1. Click OK to continue with the uninstall.
2. Follow the documented procedure to run the
clean-up utility. The procedure can be found at:
http://www.dialogic.com/support/helpweb/dxall/tn
otes/legacy/2000/tn020.htm
3. Reboot.
Known Host Install The PDKManager tool, which downloads Dialogic
®
Global Call protocol modules and country dependent
parameters to Dialogic
®
DM3 Boards, can be set up to
run automatically when DCM is started. However, after
performing an update install, PDKManager no longer
runs automatically.
Workaround: PDKManager must be rerun manually
after an update install. For further information about
PDKManager, see the Dialogic
®
Global Call Country
Dependent Parameters (CDP) for PDK Protocols
Configuration Guide.
Table 9. Issues Sorted By Type, Dialogic
®
System Release 6.0 PCI for Windows
®
(Continued)
Issue Type Defect No.
PTR
No.
SU
No.
Dialogic
®
Product(s) or
Component(s)
Description