User`s guide

Dialogic
®
System Release 6.0 PCI for Windows
®
Release Update, Rev 62 — January 30, 2008 277
Dialogic Corporation
Known IPY00022142 23256 ISDN cc_SetChanState( ) is only supported on North
American T1 PRI protocols. It is not supported on NTT
(Japanese) or European E1 protocols since the specs
of these protocols do not support
SERVICE/SERVICE_ACK messages.
Known Modular Station
Interface (MSI)
Multi-threaded applications must enclose all MSI calls
in a critical section or applications run the risk of
getting intermittent errors. Reports “No error”,
firmware does not assert but reports “cnt q overflow”.
Known Modular Station
Interface (MSI)
If the coach speaks before any conversation has taken
place between the client and the pupil, the client will
hear some background noise for a fraction of a
second. Under most circumstances, this will not be a
problem since the coach usually will not need to speak
before some conversation has taken place between
the client and the pupil.
Known Modular Station
Interface (MSI)
ms_setcde( ) fails to return a valid error message
when an invalid chan_attr is assigned.
Known Modular Station
Interface (MSI)
Setting the board parameter MSCB_ND through use
of the setbrdparm( ) function fails to configure the
volume, tone, and duration of the notify-on-add tone.
Known IPY00022053 20344 NCM API All Dialogic
®
Boards in system must be detected using
either NCM_DetectBoards( ) or
NCM_DetectBoardsEx( ) before using
NCM_StartDlgSrv( ).
Known IPY00021901 20949 NCM API All Dialogic
®
Boards in system must be detected using
either NCM_DetectBoards( ) or
NCM_DetectBoardsEx( ) before using
NCM_StartDlgSrv( ).
Known IPY00006533 31731 PBX Expert
(previously called
PBXpert)
When using PBX Expert with the Dialogic
®
DMV160LP Board, for disconnect tone supervision to
work, it must be enabled in two places. The
DisconnectTone parameter in DCM must be enabled
by selecting Yes, and the Tone_SigId4 parameter in
the board’s CONFIG file must also be enabled. For
information about enabling the Tone_SigId4
parameter, see the [CHP] Analog Voice Variant
Definitions section of the CONFIG File Parameter
Reference chapter of the Dialogic
®
DM3 Architecture
PCI Products on Windows
®
Configuration Guide.
Table 9. Issues Sorted By Type, Dialogic
®
System Release 6.0 PCI for Windows
®
(Continued)
Issue Type Defect No.
PTR
No.
SU
No.
Dialogic
®
Product(s) or
Component(s)
Description