User`s guide

Dialogic
®
System Release 6.0 PCI for Windows
®
Release Update, Rev 62 — January 30, 2008 285
Dialogic Corporation
Known
(permanent)
IPY00028427 36079 Host Install DCM fails to download the board when the cdp file
name is wrong in pdk.cfg. An error message appears
in the Event Log, but it doesn't adequately describe
the error condition.
Workaround: Check the pdk.cfg file for accuracy and
check pdk.log in ..\Dialogic\log for errors.
Known
(permanent)
IPY00028358 33991 Host Install After installation, the operating system does not have
all the drivers loaded for all the boards.
Workaround: Take the following actions.
Use Case 1: When users see the New Hardware
Wizard pop-up:
1. Click “Next”.
2. Go to the “Advanced option”.
3. Point to the location where Dialogic software is
installed, “…\dialogic\driver\” directory.
4. Click “Next”.
5. Click “Finish”.
6. Repeat this process for all the boards for which you
see the pop-up.
Use Case 2: Installation is complete and system
rebooted; not all boards are detected by DCM:
1. Go to the “Device Manager”.
2. Expand the “DM/HDSI” and see if any board has a
Yellow “!”. If yes, continue with the following steps.
3. Double click on this device.
4. Click update driver / reinstall driver.
5. Follow the same steps as above (Use Case 1).
Use Case 3: Installation is complete and system
rebooted; not all boards are detected by DCM:
1. Go to the “Device Manager”.
2. Expand the “PCI Devices” and see if any board has
“Unknown PCI Device”. If yes, continue with the
following steps:
3. Double click on this device.
4. Click update driver / reinstall driver.
5. Follow the same steps as above (Use Case 1).
Known
(permanent)
IPY00016036 27709 ISDN Q.SIG
Protocol
The Q.SIG E1 network-side firmware allows the host
to send a SETUP_ACK message even when the
incoming SETUP message contains a SENDING
COMPLETE information element. This causes a glare
condition between two DISCONNECT messages,
followed by a glare condition between two RELEASE
messages. The RELEASE_COMPLETE message is
not sent.
Table 9. Issues Sorted By Type, Dialogic
®
System Release 6.0 PCI for Windows
®
(Continued)
Issue Type Defect No.
PTR
No.
SU
No.
Dialogic
®
Product(s) or
Component(s)
Description