User`s guide

Dialogic
®
System Release 6.0 PCI for Windows
®
Release Update, Rev 62 — January 30, 2008 299
Dialogic Corporation
Resolved IPY00037161 -- 154 DM3 Fax With fax on Dialogic
®
DM/F240-1T1-PCI Boards,
when the badscanline percentage exceeds the default
value, the library and firmware both seem to send out
RTN messages to request page re-send and
retraining, but the RTN messages never get to the line.
The result is that there is never a re-send, and the
received image is distorted.
Resolved IPY00032797 -- 154 DM3 Fax The fax sender cannot wait to receive retry of digital
identification signal (DIS) message, and gets Phase E
status (EFX_COMMERRTX) transmit communication
error.
Resolved IPY00031596 36840 98 DM3 Fax A TIFF file will be faxed HI/LO resolution based on the
TIFF header and not by the sndflag parameter for
fx_sendfax( ).
Resolved IPY00028607 36356 84 DM3 Fax When using ml5_qsa_5ess firmware, a kill task occurs
if the remote side tries to send a page with 24x32
width. When fx_rcvfax( ) is called, it returns -1 with a
TFX_FAXERROR, and the kill task occurs around 2
seconds later.
Resolved IPY00028375 35507 63 DM3 Fax When you implement a send fax and receive fax in
one call by using turnaround polling, the polling bit is
not updated when the receiving fax contains more
than one page. This causes the fx_rcvfax( ) function
to complete with TM_POLLED instead of
TM_FXTERM.
Resolved IPY00028361 36091 70 DM3 Fax There is a problem when sending a multi-page fax to a
Dialogic
®
DM/V-B Board with UL3. It seems like the
fax was received successfully from the sending side,
but when opening the received tif file you only see the
first page of the fax. However the size of the file is
almost the same as the tif file sent.
Resolved IPY00028349 35898 70 DM3 Fax Dialogic
®
DMV1200BTEP Board fails to receive faxes
sent from a Sharp UX-510A fax machine. The faxtrace
utility reports an invalid image detected error, and a
TFX_FAXERROR is reported to the user application
and logged in RTF trace.
Resolved IPY00028336 35991 70 DM3 Fax There is a problem when sending a multi-page fax to a
Dialogic
®
DMV600BTEP Board with UL1. It seems like
the fax was received successfully from the sending
side, but when opening the received tif file you only
see the first page of the fax. However the size of the
file is almost the same as the tif file sent.
Resolved IPY00028326 34858 70 DM3 Fax Intermittently, fax channels get stuck during fax
reception. The DebugAngel log file reports this
condition with the following error: “Stream Id 0 Data
Size 0 Flags 4 Discarded.”
Table 9. Issues Sorted By Type, Dialogic
®
System Release 6.0 PCI for Windows
®
(Continued)
Issue Type Defect No.
PTR
No.
SU
No.
Dialogic
®
Product(s) or
Component(s)
Description