User`s guide

Dialogic
®
System Release 6.0 PCI for Windows
®
Release Update, Rev 62 — January 30, 2008 300
Dialogic Corporation
Resolved IPY00028278 35423 84 DM3 Fax Fax sender (Dialogic
®
DM/F240 Board) cannot wait to
receive retry of DIS message and gets Phase E status
(EFX_COMMERRTX).
Resolved IPY00028196 36256 84 DM3 Fax TIFF (with valid tags) fails on Dialogic
®
CPi/2400 and
DM/F Boards.
Resolved IPY00016159 27903 -- DM3 Fax When using the Dialogic
®
DM3 Fax E1 board to
receive fax, the signal gain is too high. The DM/F300
Board fails to receive fax from some old models of fax
machines. This does not happen with new models of
fax machines.
Resolved IPY00014110 28684 -- DM3 Fax When sending a fax from a Dialogic
®
DM/F240 Board
through a Dialogic
®
JCT front-end board, some fax
pages show reversed data.
Resolved IPY00009922 33056 18 DM3 Fax When sending a multi-page fax to a Dialogic
®
DMV1200BTEP Board running UL1, it appears that
the fax was received successfully from the sending
side. However, when opening the received tiff file, you
see that it only received the first page of the fax.
Resolved IPY00033584 -- 113 DM3 Firmware Double ringback tone in China causes false cadence
break on Dialogic
®
DM/V-A and DM/V-B Boards.
Resolved IPY00031561 36775 108 DM3 Firmware Intermittent blue screens occur when trying to shut
down or reboot the OS with Dialogic
®
Boards
downloaded.
Resolved IPY00028658 36606 90 DM3 Firmware While processing calls on ISDN lines with Dialogic
®
DM/V-B Boards, memory pool corruptions occur that
make the firmware reject all incoming calls on the
span with Circuit Not Available cause code.
Resolved IPY00028557 36302 90 DM3 Firmware gc_BlindTransfer( ) fails after several days of normal
operations. The system answers calls successfully, but
blind transfer fails.
Resolved IPY00028549 35901 154 DM3 Firmware QERROR_WARNING messages appear in
Dm3StdErr log, and then all channels lock up.
Resolved IPY00028430 36333 88 DM3 Firmware After running for several days, the driver side goes out
of sync and the DM/V side reports AIS (blue alarm)
error. The issue is seen only when brd_SendAlive( )
feature is enabled.
Resolved IPY00028417 35650 71 DM3 Firmware ml2_qsa media loads (for example,
ml2_qsa_5ess.pcd) do not support exit notification
properly.
Resolved IPY00028373 35431 62 DM3 Firmware DCM doesn’t start when using media load 10b and
E1CC (clear channel) mode (ml10b_qsb_4_e1cc.pcd)
on Dialogic
®
DMV1200BTEP Board.
Table 9. Issues Sorted By Type, Dialogic
®
System Release 6.0 PCI for Windows
®
(Continued)
Issue Type Defect No.
PTR
No.
SU
No.
Dialogic
®
Product(s) or
Component(s)
Description