User`s guide

Dialogic
®
System Release 6.0 PCI for Windows
®
Release Update, Rev 62 — January 30, 2008 303
Dialogic Corporation
Resolved IPY00010914 36429 84 DM3 IP If application uses both H.323 and SIP,
gc_ResetLineDev( ) called before gc_WaitCall( )
locks up channel on Dialogic
®
DM/IP241-1T1 Board,
Resolved IPY00010900 36349 98 DM3 IP The PARM_TX_ADJVOL_ and PARM_RX_ADJVOL_
parameters in the ipmlib.h header file are defined via
#defines but have semicolons after them, which make
it hard to compile applications built using it.
Resolved IPY00010760 36647 98 DM3 IP When a call is placed to an IP address that does not
exist or to a valid IP address that does not have a SIP
phone active, you cannot call gc_DropCall( ) to
disconnect the call; you have to wait for the 64-second
INVITE timer to expire before you receive a
GCEV_DROPCALL.
Resolved IPY00008651 32111 18 DM3 Media Span When running high density Dialogic
®
DM3 Media
Span systems, the Windows
®
Event Viewer may
become populated with SRAM corruption errors.
There will be no other system impact.
Resolved IPY00031590 36755 154 DM3 Network gc_BlindTransfer( ) is not working on the Dialogic
®
DMV160LS Board.
Resolved IPY00028555 36110 154 DM3 Network With ms_SetMsgWaitInd( ), if the user of the
Dialogic
®
DI Board station picks up prior to the
function returning, it renders the device useless for up
to 30 seconds.
Resolved IPY00028516 35001 154 DM3 Network Hook flash is sometimes not detected on Dialogic
®
DI
Boards when it is issued from its station interface
during the ring cycle.
Resolved IPY00028444 35763 124 DM3 Network GCEV_PROGRESSING message not sent to
application.
Resolved IPY00028408 35117 92 DM3 Network Board crashes when using gc_SetInfoElem( ) to add
“Display Name” IE prior to calling gc_AnswerCall( )
when connected to Nortel switch that has been
configured for 5ESS.
Resolved IPY00028406 35210 56 DM3 Network PDKManager is encountering problems in registering
the protocol for Dialogic
®
DM3 Boards, but the
problems are not reported to the user and there are
failures after the application starts.
Resolved IPY00028293 35281 62 DM3 Network The gc_BlindTransfer( ) function is not working
properly when using pdk_us_ls_fxs protocol with
CSP_WaitDialToneEnabled = 1 and
CSP_DialToneWaitTime =5000 (Default). If the blind
transfer fails because dial tone is not available on the
line, then gc_BlindTransfer( ) should return a
GCEV_TASKFAIL event after 5 seconds. However,
this is not happening; the channel hangs without
TASKFAIL.
Table 9. Issues Sorted By Type, Dialogic
®
System Release 6.0 PCI for Windows
®
(Continued)
Issue Type Defect No.
PTR
No.
SU
No.
Dialogic
®
Product(s) or
Component(s)
Description